Maevi Power Relay User manual
Page 1 of 5
Power Relay
Quick Start Guide
Page 2 of 5
Introduction
It allows you to turn the power on and off remotely as well as setting on/off schedule from
the mobile app.
Get to know your device
Button
Reset Button
• Return this device to default factory settings.
• Set this device on pairing mode so as to pair with a wireless switch.
• Please use a pin key tool to press and hold the reset button for ten seconds until
the LED light flashes twice.
LED Indicator
LED Status
What It means
LED flashing
The device has not joined a network
Green LED solid on
The load is ON
Red LED solid on
The load is OFF
LED flashing three times
Enter pairing mode or return to default
factory settings
Get Started
To get started, you will need:
• A Smart Gateway
• A Power Relay
• The mobile app
Then follow the steps below:-
1. Install the Power Relay.
The installation diagram below is one example of a possible application.
Page 3 of 5
2. Open Maevi (Maevi Smart Home) app and go to “Home Automation” tab. Tap the plus
circle button at the below right of the screen to pair the Power Relay with the
Gateway.
Tip: for this step, you could also press “Z” button on the gateway for 2 seconds until the
LED indicator turns solid blue
Pairing Device
Page 4 of 5
3. The power relay will be added into the gateway, the flashing LED turns solid if pairing
is successful. Please go to the app to check if it is successfully added.
Device name
ON/OFF
ON/OFF
Device Details
Page 5 of 5
Scheduling Device
4. Create turn ON/OFF scheduling device
