Magnadyne RV2458 User manual

For Technical Assistance, please call [phone],
or visit www.magnadyne.com
Quickstart Guide
RV2458 Router

2
RV2458 Software Quickstart Guide
Press power button on the
RV2458 to power up the Router
(approximately 2 min).
NOTE: If your phone is being used as a
hot spot connection it will not be able
to be used as a configuration device.
A second device will be required.
Step 1 Step 2
Power
Router
Extender
Blue & Solid
Blue & Flashing
Blue & Flashing

3
In the Password field type in
the password MV2458WiFi
and click the Join button.
Password:
MV2458WiFi
Wait until your device is
connected to the
MV2458-2.4G Network.
Step 3 Step 4
*Case Sensitive

4
Go to your web browser and in
the address field type in
192.168.10.1 and click Go or
hit Enter.
The Login screen will open. In
the Password field type in the
password admin and click
the Login button.
RV2458 Software Quickstart Guide
Step 5 Step 6
Address:
192.168.10.1
Password:
admin
*Case Sensitive

5
Wait until the scanning
countdown has completed.
The Available WiFi List screen
will appear. Click on the WiFi
Network that you would like
the Router to connect to.
If the scroll bar isn’t showing
and you are using a Mac
Computer, move the cursor up
and down over the SSID
names and the scroll bar
should appear.
Step 7 Step 8

6
The password pop-up window will appear. Type in the
password for the chosen WiFi host and click on the Connect
button.
Please acquire password from WiFi Host at your location.
If previously connected, the password will refresh
automatically from your connection history.
If the unit will not connect at this step, it may not have
finished it’s 2 minute boot cycle. Start again from Step 1
and wait 2 minutes for boot cycle to complete.
RV2458 Software Quickstart Guide
Step 9

7
In the Password field type in
the password admin and click
the Login button. If login is
successful, the unit will
proceed to Step 13.
Step 11
Password:
admin
*Case Sensitive
The Connecting countdown
page will complete and then the
Login screen will open.
You must wait 2 minutes
after hitting the connect button
for the unit to complete it’s
connection. 45 seconds will
result in a failed connection.
Step 10
45

8Copyright © 2017 Magnadyne Corp. RV-Link_RV2458_QS_Rev. A
RV2458 Software Quickstart Guide
The Status Screen will appear
showing the connected Network
under the title MV2400 (Outside)
Information.
Congratulations, Setup Complete.
Step 13
If the password was not typed
correctly a pop-up window will
appear stating that the
connection to the Network failed.
Click the OK button. The unit will
return to Step 7 and scan again.
Double check that you are typing
the correct Network password in.
Step 12