Mangar AB0003 User manual

Adjustable Bath & Shower Chair - User Instructions MI0236 issue 1
The Adjustable Bath & Shower Chair by Mangar International is intended to be used in a bath or shower to
provide a stable, seated support, where a user is unable to stand for long periods. It may be used with or
without the backrest.
Contents
2 x Legs inc. 4 x captive screws.
5 x Round head screws.
5 x Saddle washers.
5 x Spring washers.
1 x Seat.
1 x Backrest.
2 x Backrest support tubes.
1 x User instructions.
Assembly
Tools required: Philips screwdriver.
Seat section (Fig.1)
Place the seat upside down on a at surface
and align the legs so that the numbers
1& 2stamped on the legs correspond to the
numbers 1& 2 moulded into the seat.
Loosely secure the four captive screws (A).
Fit the spring washer (B) and saddle washer
(C) to the screw (D) and insert into the centre
hole before fully tightening.
Fully tighten the four captive screws (A).
Backrest section (Figs.2&3)
Align the holes in the backrest support tubes
with the holes in the backrest.
Fit the spring washers (B) and saddle washers
(C) to the screws (D) and insert into the four
holes before fully tightening.
Insert the backrest tubes into the guide tubes
on the underside of the seat ensuring that
the snap buttons (E) locate in the guide tube
holes.
1.
2.
3.
4.
5.
6.
7.
(Model: AB0003)
2
1
A
C
B
D
Fig. 1
D
CB
Fig. 2
Fig. 3
E
freedom through lightweight solutions

Mangar International reserves the right to alter product specications and/or any of the information contained within this document without notice.
Mangar International
Presteigne, Powys, Wales, UK. LD8 2UF
tel: [phone]
fax: [phone]
[email protected]
www.mangarinternational.co.uk
Height Adjustment
Adjust the legs to the desired height by depressing
the snap button (F g.4) and sliding the leg extension
up or down the frame tube until the button snaps into
the appropriate adjustment hole.
Ensure that all four leg extensions are secured to the
same adjustment holes to ensure even height. The
adjustment holes are numbered to assist with even
alignment.
WARNING: Ensure that all four legs are adjusted to the
same height and that each snap button is fully located.
1.
2.
Using the Bath & Shower Chair
Position the chair in the bath or shower ensuring that all
four feet are making contact with the bath/shower tray.
Sit centrally on the seat.
Safety Precautions
DO NOT exceed the maximum user weight limit.
DO NOT stand on the seat.
DO NOT use if the rubber feet are damaged.
Inspect at regular intervals for wear and damage.
Cleaning
All components can be cleaned with a proprietary
liquid cleaner or disinfectant.
Specications
Maximum User Weight: 136Kg (21st)
Seat Height (min/max): 36 cm/53.5 cm
Seat Size: 49.5 x 29.5 cm
Footprint (min/max): 45 x 47 cm / 52 x 50 cm
•
•
•
•
•
•
•
41 cm
22.5 cm
33.5 cm
53.5 cm
(max)
36 cm
(min)
52 cm (max)
45 cm (min)
50 cm (max)
47 cm (min)
F
Fig. 4
Warranty
Mangar International guarantees this product for a period of one year.
The guarantee is given against defects in the product. The guarantee is not valid in the case of
fair wear and tear, wilful damage, common neglect, misuse or unauthorised alteration or repair by
unqualied persons.
The following statements do not affect the consumer’s statutory rights. This product is sold on the understanding that in the
event of any defect of manufacture or material appearing within one year of the date of receipt of this product, the product
will be repaired or replaced free of charge providing that:
(a) Reasonable evidence is provided (e.g. purchase invoice, delivery note) that the product was not purchased more
than one year prior to the date of the claim.
(b) The defect is not attributable to accidental damage (either in transit or otherwise), misuse or unauthorised repair.