Mania SOLSENSE User manual

INSTRUCTIONS
SOLSENSE MOTION SENSOR
LED LIGHT
PACKAGE CONTENTS
•Solsense light
•Light mount
•3 screws and plastic plugs
•User’s manual
TECHNICAL SPECIFICATIONS
•Illuminated area: 50–80 m²
•IP rating: IP65
•Solar panel: 5 V, 300 mA
•Output power: 4 W
•Luminous flux: 500 lm
•Battery: lithium, 3.7 V, 1200 mAh
•Charging time: 4–6 h
•Sensor range: 0–6 m
•Sensor angle: 120°
•Material: PC, ABS
•Size: 3 × 11 × 14 cm
INSTALLATION
Follow the steps pictured in the chart below to install
the Solsense light.
1. Align the light mount on a wall where you
want to install the Solsense light. Use a
marker to mark the hole locations.
2. Using an electric drill, drill three holes into
the wall where you marked the locations.
Make sure you use a drill bit with the same
diameter as the plastic plugs.
3. Insert the provided plastic plugs into the
holes. Use a hammer to push the plugs
completely into the holes. Note that the
plugs must fit snugly. If they feel loose, the
plugs will be unable to grasp the screws
properly.
4. Use a screwdriver and the three provided
screws to screw the light mount onto the
wall. Tighten the screws firmly.
5. There is a threaded hole on the bottom side
of your Solsense light. Screw the Solsense
light on the light mount and tighten the
plastic ring located on the thread of the
mount.
6. Loosen the tightening knob on the light
mount to adjust the angle and direction of
the Solsense light. Tighten the knob to
secure the position. The device is now ready
to use.
HOW TO USE
•The Solsense light works in three different
lighting modes. Use the button on the
bottom side of the device to cycle through
lighting modes.
•Mode 1: When motion is detected, the light
shines with its full intensity. Otherwise, the
light is dimmed.
•Mode 2: When motion is detected, the light
shines with its full intensity. Otherwise, the
light is off.
•Mode 3: The light is always on. After three
hours, the light will automatically switch to
mode 2.
•To turn off the device, press the button
again.

WARNINGS
•This device uses a solar panel to charge
during the day. Make sure that nothing is
covering the solar panel. Otherwise, the light
will not charge properly.
•Make sure that there is no strong light
directed onto the solar panel after dark.
Otherwise, it will enter the charging mode,
and the light will not work.
•Do not intentionally shine into the eyes or
face.
•Do not attempt to open the housing or
replace the lamp of the device.
•Before each use, check if the light has any
visible damage or defect. Do not use it if it is
damaged!
•Use the product only for its intended
purpose.
•Do not disassemble or modify in any way.
WARRANTY
The warranty is valid for 24 months. You can claim it
from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš,
Slovenia, for a replacement product or a refund.
Send us your order number and purchase date in the
email, which is available by clicking on our logo in the
bottom right corner. The product has a lifetime of 24
months from the date of collection.
WEEE disposal and recycling symbol.
The WEEE symbol is attached to the
product in compliance with the EU
directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE). It is intended to deter the
improper disposal of this product and
to promote reuse and recycling.