Manta 5 HYDROFOILER XE-1 Operation instructions

FIT BATTERY TRAY
This tutorial shows how to fit the Battery Tray on the XE-1.
1. Work Instruction – Fit Battery Tray
TOOLS REQUIRED
ID
Description
Task
M4 Hex Key
Fit M6 Countersink Head Screws
1.1 Push cable to the side and fit the Stirrup to the Frame. The ideal position is with a gap of 65 mm
between the Rear Buoyancy and the Stirrup.
INFORMATION: The Stirrup is used as fastener for and locks the Front Buoyancy into place. Positioning the
Stirrup with the 65 mm gap to the Rear Buoyancy positions the Stirrup in the ideal position for fitting the
Front Buoyancy later.he Battery Tray can remain in place during this procedure.
1.2 Thread the cable with the connector through the keyhole and position the Battery Tray (with warning
labels attached) to align the screw holes with the corresponding threaded holes in the Frame brackets.

1.3 Position the Battery Latches with M8 Set Screws on the right-hand side of the Hydrofoiler XE-1 so that
the fastener holes and edges align with the mating features on the Battery Tray.
1.4 Fit the M6 countersink head screws through the Battery Latches and Battery Tray into the threaded
brackets on the bike Frame. Fit all four screws loosely using the taper shape of the screw heads to align the
Battery Latches. The Battery Tray position can now be adjusted to align with the Battery Latches before the
screws are fully fastened.

1.5 With the Battery Tray aligned, fasten the screws to a torque value of 5 Nm. [Tools: 4mm Hex]