Mantua Manufacturing CVT-3 User manual

Figure 4
CVT-3 Instructions -page 1
Step 1
Insert SIDE RAILS into headboard &
footboard. If installing hook-on rails, make
sure the hook-on brackets grip the post pins
inside your headboard and footboard. If
installing bolt-on rails, make sure all nuts and
bolts are tightened. See Figure 1.
Step 3
Swing out cross supports to 90°
angles. Figure 3.
Step 4
Slide clamp with leg onto end of angle bar
Figure 4 ( A ) . O v erlap angle bars and slide
clamp with leg onto both angle bars as shown
in Figure 4 ( B ) . When you achieve the desired
width, tighten thumb screw. Adjust the legs
so they touch the floor.
Figure 1
Figure 3
FULL TO QUEEN CONVERTER RAILS ASSEMBLY INSTRUCTIONS
Step 2
Insert a threaded glide in each
center support clamp. Figure 2.
Figure 2
 
 M 

CVT-3 Instructions - page 2
Step 5
Using bolts and nuts attach the center support
bar to the side rails as shown in Figure 5.
Step 6
Slide clamp leg onto end of angle bar.
Figure 6 ( A ) . O v erlap angle bars and slide
clamp leg onto both angle bars as shown in
Figure 6 ( B ) . Fully tighten the center support
thumb screw. Adjust the center support leg
so it touches the floor. Figure 6 .
Step 7
Attach each of the four mattress retainer
brackets to the bed rails using a bolt and
wing nut. Use the large oval holes. See
Figure 7(A), inset. Before tightening,
position your box spring on the side rails
and adjust the MATTRESS RETAINER
BRACKETS for a tight fit. Lock the
brackets in place by tightening WING
NUTS.
Figure 5 .
Figure 6 .
Step 8
Check your bed rails at the footboard. There may be a sharp edge protruding on the rail. We've
included rubber shin-guards for the left and right footboard rail. You will need to trim them with scissors
to fit your particular bed.
Figure 7
7(A)