Mantua Manufacturing Universal Grab-and-Go User manual

Universal Grab-and-Go
Bed Frame Assembly Instructions
Instructions
Parts Included
• Bed Frame Rails - 4
• Middle Connector - 2
• Center Rails - 2
• Nylon Glides - 2
• Stem Glides - 4
Step 1
Headboard Brackets
Swing out cross arms on side rails. Slotted
brackets should be at the head of the bed.
Step 3
Slide sockets into 4 inserts on legs of side
rails. Insert stem glides into sockets.
Step 4
Slide end caps over the foot ends of the
side rails.
• Plastic Sockets - 4
• End Caps - 2
• Bolts - 8
• Nuts - 8
• Plug Locks - 4
Step 2
Overlap side rails and attach with bolt and
nut. Tighten with wrench. Repeat on other
side.

Copyright 2016 Mantua Mfg. Co.
www.mantuabeds.com [phone] [e-mail]
FOR TWIN, FULL, OR QUEEN - Select the keyholes for the size of your bed. Insert rivet buttons
on cross arms into selected keyholes. Slide arms away from each other to lock the position. Then
insert plug lock into keyhole at the end of the overlap. Repeat on the other side of the bed.
Step 5
FOR KING OR CALIFORNIA KING - Choose the keyholes on the middle connector for the size of
your bed. Insert rivets on cross arm into selected keyholes, and insert rivets on middle connector
into last (Queen) keyholes of side arm. Slide into place, then insert plug locks into keyhole at each
end of the overlap. Repeat at other end of the bed.
Slide glides over the legs on the center rail.
Step 6
Position center rails in the middle of the bed frame.
Overlap open ends of center rail and attach with
bolt and nut. Secure each end of center rail to
bed frame with bolt and nut. Tighten with wrench.
Center rail can be used for all sizes.
Step 7