Maplin N38HN User manual

Instruction Manual
Remote Socket Set 5-Pack Order Code: N38HN
A. Function
1. LED on the transmitter (remote control) indicates that a signal is being transmitted.
2. Indicator light on the receiver (socket) indicates that the socket is working.
3. Both transmitter (remote control) and receiver (socket) have 4 channels and 4 codes.
4. The code of the transmitter (remote control) and receiver (socket) can be adjusted.
B. The Product:
Ⅰ
Ⅳ
Ⅲ
Ⅱ
1
4
3
2
1
23
4
5
6
7
8
9
No.
Description
No.
Description
No.
Description
1
LED light
4
Code adjustment switch
7
Code adjustment dial
2
ON/OFF Channels
5
LED light
8
Channel adjustment dial
3
LED light
6
Battery cover
9
Plug
C. Code and ChannelAdjustment
1. Code adjustment:
Adjust the code of the transmitter and receiver so that they each use the same code (There are 4
corresponding codes). Please refer to the images below:

1 2 3 4
2. Channel adjustment:
Adjust the channel of receiver to the corresponding channel of the transmitter, please see the
following images: there are 4 corresponding channels
1 2 3 4
PS: Please change the code if you encounter interference with another socket.
D. Operation:
1．Adjust the code of both transmitter and receiver so that they are using the same code.
2．Adjust the channel of the receiver to the corresponding channel of the transmitter.
3．Plug your electrical appliance into a receiver socket. Then plug the receiver into the AC socket.
4．Press the corresponding channel on the remote control. Press the “ON” button and the socket
will turn on and the LED will illuminate. Press the “OFF” button and the socket will switch off
and the LED light will go off.
E. Specifications:
1. Transmitter battery: 12V/23A (Order Code JG91 for replacement)
2. Transmitter radio frequency: 433.92MHz
3. Receiver voltage: 220/240V / 50Hz / IP20
4. Receiver maximum wattage: 3680W
5. Transmittion range: Typically 30m (clear line of sight)
WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or
general waste. It should be handed over to the applicable collection point for the
recycling of electrical and electronic equipment, or returned to the supplier for
disposal.
Internal / Supplied Batteries
This symbol on the battery indicates that the battery is to be collected separately.
This battery is designed for separate collection at an appropriate collection point.