Marathon MFF208WFD User manual

20.8 cu.ft. French door
bottom mount refrigerator
MFF208WFD | MFF208SSFD
Congratulations on the purchase of your new Marathon Refrigerator!
To activate your Warranty, please register your appliance at www.stirlingmarathon.com
or by completing and mailing the enclosed Warranty Registration Card. We are confident
you will have years of hassle-free enjoyment and ask that you please retain the Use &
Care Guide for future reference and your safety.
Before installing please, read your Use & Care Guide carefully and pay special attention
to the Safety & Warning information outlined in the following pages.
For immediate assistance: 1-844-309-9777
www.stirlingmarathon.com

3
Note: Above picture is for reference only. The actual appliance maybe slightly different.
1. Temperature Control Panel & LED Light
2. Wine Rack
3. Freezer Door Shelf
4. Refrigerator Adjustable Door Bin
5. Crispers
6. Freezer Drawer
OVERVIEW
MFF208WFD | MFF208SSFD

4
•This appliance is designed to be free-standing only, and should not be recessed or built-in.
•This unit is not designed for use in a garage or any other outside installation
•Ambient temperature below 50°F (10°C) or above 85°F (29.4°C) will hinder the performance of this
appliance.
•Avoid locating the refrigerator in moist areas.
•Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
•Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
•Select a location with enough space for the refrigerator doors to open easily;
•Select a location with level (or nearly level) flooring;
•Allow sufficient space to install the refrigerator on a flat surface;
•Allow clearance to the right, left, back and top when installing. This will help reduce power consumption
and keep your energy bills lower.
Installing Your Refrigerator
Installation
* The above figures are a guideline for installation purposes.
The actual dimensions of the unit may vary slightly.
MFF208WFD | MFF208SSFD
35 15/16'' (911.86 mm)
27 13/16'' (706.12 mm)
70 1/4'' (1780.54 mm)
69 '' (1753 mm)

Levelling the Refrigerator
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal alignments will not be
covered properly.
When the refrigerator stays in the packing box, plastic feet are in tightened state.
After carrying it out from the packing box for placement, please make sure to
adjust two front plastic feet until the height is suitable; just adjust two plastic feet
with a wrench or directly by hand.
Plastic feet and rear rollers must touch the ground to prevent the refrigerator
from movement, vibration or noise.
When moving the refrigerator, adjust plastic feet counterclockwise to keep them
off the ground, and then push the refrigerator gently to move it.
5
MFF208WFD | MFF208SSFD

6
Temperature Control
1.Fridge temperature range: 2-8℃ (Default value 5℃)
2.Freezer temperature range: -23-15℃ (Default value -18℃)
Set temperature range: Fahrenheit degree mode
1. Fridge temperature range: 32-46°F (Default value 41°F)
2. Freezer temperature range: -10-5°F (Default value 0°F)
Setting the Temperature Control
Your unit has one control for regulating the temperature. The temperature control is located on the outside of
the refrigerator compartment door.
The default temperature is displayed in Fahrenheit when the unit is first powered on. Press and hold the
"MODE" button 5 seconds, to switch between °C and °F. Other buttons use the same method to switch
between two modes.
Set temperature range: Celsius degree mode
•The first time you turn the unit on, the unit will start at the factory-set default temperature, which is 41°F
(5°C) in the refrigerator compartment and 0°F (-18°C) in the freezer compartment.
•The first time you turn the unit on, adjust the temperature in the refrigerator compartment to 37ºF (3°C)
and run for at least 4 hours before placing food inside. This will ensure that the freezer compartment is
thoroughly chilled and the refrigerator compartment is stabilized before food is placed inside. Then adjust
the temperature setting to your desired setting.
•To adjust the temperature in each zone, press the appropriate zone button, and the selected zone will flash
on and off. The temperature will change according to the pre-set temperatures as shown below. You will
hear a bell chime with each press of the control panel buttons.
FREEZER MODEFRIDGE
QUICK
COOL
QUICK
FREEZE SMART
Quick Cool
icon
Quick Freeze
icon
Smart icon
Mode control
MFF208WFD | MFF208SSFD