Maro D'Italia FP208 User manual

Hot water inlet
Cold water inlet
Product introduction(round)
Knob (temperature)
Knob (wash)
Mounting plate
Rear Wash Front Wash
(for women)
BIDET SEAT INSTRUCTION
②
②
OFF
① ①
①
③
③
OFF
Hot Cold
Knob for cold/hot options
1) Clockwise--Cold water
2) Anti-clock wish--Hot water
Knob for cleaning
1) Position ①: Nozzle clean
2) Position ②: Rear cleaning
3) Position ③: Front wash for women
Function introduction
Quick release
button
TOILET FIT GUIDE:
Use this guide to choose the seat that will best fit your toilet
Measure the distance from the bolt holes to the front of the
toilet bowl to determine the shape.
If is 45.5-49.5cm, you need a V Shape Seat
If A is 40.5-45cm, you need an O Shape Seat
45.5 49.5cm 40.5 45.0cm
≥3.17cm
A
A
A
The distance from the center of the bolt holes to the tank
must be at leat 3.17cm
B

2. Unscrew toilet seat
1. Clean toilet
1) Turn the water valve off
2) Empty the tank water
3) Clean and drain toilet seat
T-adaptor washers
Stainless hose
Hot water sealConnector and nut
Tube
Mounting plate
Plastic bolts&nuts Top mounting bolts
Sliding Plates(2pcs) Taflon tape
(optional)
Water Towel
Paper Screwdriver
Parts for installation Tools needed for installation
(for cold water)
T-adaptor washers
(for hot water) (for tube)

3A. Fix mounting plate on toilet
1) Put mounting plate on toilet
2) Put sliding plates on mounting plate
3) Put bolts and nuts to screw the mounting plate
1) Insert black rubber expansion tubes to the hole of toilet
2) Put the mounting plate on toilet
3) Put sliding plates on the mounting plate
4) Put the stainless steel plate on the sliding plate
5) Put bolts to screw the mounting plate.
Plastic bolt
Sliding plate
Mounting plate
Plastic nut
3B. Fix mounting plate on toilet
4. Re-install bidet seat
Aim the slot, push the bidet seat
Bolt
Sliding plate
Mounting plate
stainless steel plate
black rubber
expansion tubes

6. Unscrew cold water supply
Stainless hose T-adaptor
Washer
7. Install t-adaptor
5. Turn cold water supply off
8. Turn hot water supply off

T-adaptor
T-adaptor
9. Connect hot water tube
Connector
Nut
Tube
Nut Washer
10. Checking leakage
Turn on the water supply to check the water leakage
If not connect to hot water supply,
screw the hot water seal.

②
②OFF
① ①
①
③
③
OFF
11. Usage introduction
ColdHot
Knob for cold/hot options
1) Clockwise--Cold water
2) Anti-clock wish--Hot water
Knob for cleaning
1) Position ①: Nozzle clean
2) Position ②: Rear cleaning
3) Position ③: Front wash for women