Martha Stewart Living Snow-People Lawn Ornament Operator's manual

© 2014 Martha Stewart Living Omnimedia, Inc. All rights reserved. For personal use only, not for commercial use.
from Martha Stewart Living | www.marthastewart.com
Assembly Plan: Snow-People Lawn Ornament
indicates hex nut placement
INSTRUCTIONS
Cut ashing to lengths listed below, then
drill holes where indicated. Holes are
listed in order: #1, 2, 3, 4, 5, 6, and 7.
Roll each piece of ashing so holes #1,
3, 5, and 7 align. Place hex huts where
shown and move snowballs down the rod
until they reach the heights indicated on
diagram.
For head:
1. Cut 53-inch piece of ashing
2. Drill holes at 1, 8, 15, 23½,
32, 42, and 52 inches.
For middle:
3. Cut 76” piece of ashing
4. Drills holes at 1, 11½, 22,
34¼, 46½, 60¾, and 75 inches.
For bottom:
5. Cut 106-inch piece of ashing
6. Drill holes at 1, 16, 31,
47¼, 63½, 84¼, and 105 inches.
Move snowballs down threaded rod until
bottom of hat is 5 inches from top of rod,
bottom of head is 11½ inches from top of
rod,
bottom of middle is 21 inches from top of
rod, and bottom of biggest snowball is 34
inches from top of rod.
5 inches from top of
rod
11½ inches from top
of rod
20½ inches from top
of rod
34 inches from top
of rod

© 2014 Martha Stewart Living Omnimedia, Inc. All rights reserved. For personal use only, not for commercial use.
from Martha Stewart Living | www.marthastewart.com
Assembly Plan: Snow-People Lawn Ornament
INSTRUCTIONS
Cut ashing to lengths listed below, then drill
holes where indicated. Holes are listed in
order: #1, 2, 3, 4, 5, 6, and 7. Roll each piece
of ashing so holes #1, 3, 5, and 7 align. Place
hex huts where shown and move snowballs
down the rod until they reach the heights
indicated on diagram.
For head:
1. Cut 60 inch-long piece of ashing.
2. Drill holes at 1, 9½, 18, 27½, 37, 48, and 59
inches.
For middle:
3. Cut 83-inch piece of ashing.
4. Drill holes at 1, 11½, 22, 36, 50, 66, and 82
inches.
For bottom:
5. Cut 111-inch piece of ashing.
6. Drill holes at 1, 13½, 26, 44, 62, 86, and 110
inches.
indicates hex nut placement
5 inches from top of
rod
12 inches from top
of rod
22 inches from top
of rod
37 inches from top
of rod