Master Eclipse Manual

R
Instrucion guide ECLIPSE BATTERY_ENG rev01 26.05.12
433,92 MHz
www.mastermotion.eu
Instruction guide for ECLIPSE BATTERY assembling.
OK
NO
X
OK
OK

Dear customer, thank you for purchasing a MASTER product.
Here you will find important information regarding the methods of use and the safety of installation.
ECLIPSE BATTERY ia a sun and wind sensor and it can communicate via radio with receiving modules, inside or outside the motor, working at
frequency and made by the same producer.
Comply with the following information and keep for future reference.
The producer cannot be consider responsible for any damages due to improper, wrong or unreasonable use.
FORACORRECT INSTALLATION, IT IS RECOMMENDED TO READ THE FOLLOWING IMPORTANT INFORMATION.
433,92 MHz
Warning
Environmental conservation!
Environmental conservation is an everyone’s duty!
MASTER uses packaging recyclable materials.
Dispose materials on the proper containers, complying with the law in force in your locality.
This product may have substances that are polluting for the environment and dangerous for the health. At hte end of the product life cycle,
carefully comply with the waste disposal rules. It is strictly forbidden to dispose the product on the domestic waste.
It is advisable in areas with strong interference (for xample, near police stations, airports, ports, hospital, etc.).Atechnical
inspection is in any case advisable before installing any radio system in order to identify sources of interference.
Radio systems can be used where possible disturbances or malfunctioning of the transmitter or the receiver do not pose a risk factor, or if the risk
factor is cancelled by suitable safety systems.
The presence of radio device operating on the same transmission frequency ( ) can interfere with the radio receiver of the motor and so
reduce the range of the system and limit the functionality of the installation.
to avoid using radio systems
433,92 MHz
01. Important notes on radio systems
GUIDANCE
SECURITY
01.
03.
04.
05.
06.
07.
08.
09.
10.
11.
12.
The product must be installed by qualified technical personnel so as to comply with the standards and laws in force in your locality.
Do not modify or replace parts without the manufacturer’s permission.
If there are several radio motors in the same system, the minimum distance between them must not be less than 1,5 metres.
Aviolent shock and the use of unsuitable tools can cause the brackage of internal or external parts of the device.
Do not drill or tamper the device for any reason.
Do not install the product near metal surfaces.
Operating on the device with caution, using suitable tools.
Check that the sensor has been installed on the correct position and well exposed to the wind and that there are no obstacles to the blades rotation.
Check that the sensor placed over the blades is not obscured by trees, gutters, etc.
This sensor has not been studied for working with blades turned upside down (as on the first picture).
It is advisable to periodically clean the sensor dome with a damp cloth in order to always have the maximum ability to detect the sun.
02. Check that the package is intact and has not suffered damage in transit.
02. Warnings on installation
03. Technical characteristics (related to 20°C working temperature)
- Power supply :
- Battery duration :
- Working temperature :
- Working frequency :
3V battery
5 years
-20°C / +55°C
433,92 MHz
(estimate)
- Supported sensors :
- Wind threshold : 5 35
- Sun threshold : 1 45
sun and wind
from to Km/h
from to Klux
1
ON
1
ON
1 2
ONCE THE SWITCH IS « »
THE ECLIPSE BATTERY
SIGNALS ITS ACTIVATION
THROUGH TWO LEDS
LIGHTING.
IF THIS DOES NOT HAPPEN
PUT SWITCH ON THE « »
POSITION, WAIT 30 seconds
AND REPEAT THE OPERATION.
ON
OFF
OPEN THE ECLIPSE BATTERY
COVER AND SWITCH IT « »
THROUGH THE SWITCH
ON THE BATTERY
ON
04. ECLIPSE BATTERY switching on.
05. Sun / Wind threshold table and visual signals :
6
5
4
3
2
1
15 Klux
8 Klux
1 Klux
45 Klux
30 Klux
22 Klux
Velocità
Soglia
SUN threshold
6
5
4
3
2
1
20 Km/h
15 Km/h
10 Km/h
35 Km/h
30 Km/h
25 Km/h
Velocità
Soglia
factory set up
(*) factory set up (*)
(*)
(*)
SUN FUNCTION :
ECLIPSE BATTERY sends a sun presence
transmission when intensity of the sun
exceeds the set sun threshold for at least 2,5
minutes, and sends a sun absence
transmission when the intensity of the sun is
lower that the set threshold for at least 18
minutes.
WIND FUNCTION :
ECLIPSE BATTERY sends a wind danger
transmission to the tuned receiving modules
when the wind speed exceeds the set
threshold for longer than 3 seconds. It exits the
wind alarm mode after 8 minutes from the last
gust over the set threshold. The sun control is
off during the wind alarm mode.
In order to preserve the duration of the mounted battery, no signals are sent during the normal working. Only when a transmission due to weather changing
is sent (from wind presence to absence, from sun presence to absence or vice versa) the red led briefly lights.
WIND threshold

06. Memorize or delete ECLIPSE BATTERY on the receiver.
WITHING
8 sec.
WAIT
10 sec.
USING A STORED TRANSMITTER
BRING THE MOTOR TO AN
INTERMEDIATE POSITION.
INTERMEDIATE
POSITION
(around half way).
HOLD « » ON THE
TRANSMITTER UNTIL THE MOTOR
OPERATES 2 UPWARD MOVEMENTS.
PROG
1
1
TO MEMORIZE
TO DELETE
«1»HOLD BUTTON
ON THE SENSOR
FOR AROUND 3 sec.
HOLD BUTTON
FOR
2 seconds.
«2»
Flash = 10 Km/h
Flashes = 15 Km/h
= 20 Km/h
= 25 Km/h
= 30 Km/h
= 35 Km/h
Flashes
Flashes
Flashes
Flashes
1
2
3
4
5
6
Time = 10 Km/h
Times = 15 Km/h
= 20 Km/h
= 25 Km/h
= 30 Km/h
= 35 Km/h
Times
Times
Times
Times
07. Wind threshold adjusting.
2
THE RED LED FLASHES THE
SAME TIMES OF THE
CURRENTLY SET WIND
THRESHOLD
PRESS BUTTON « » THE SAME TIMES
OF THE DESIRED THRESHOLD
FOLLOWING THE « »
TABLE
1
WIND THRESHOLD
Flash = 10 Km/h
= 15 Km/h
= 20 Km/h
= 25 Km/h
= 30 Km/h
= 35 Km/h
Flashes
Flashes
Flashes
Flashes
Flashes
THE NUMBER OF FLASHES
SIGNALS THE NEW
SET THRESHOLD In order to check the right working
of the wind alarm bring the motor
to an intermediate position and
ensure that the wind alarm moves
the motor upward.
IF THE RECEIVING DEVICE IS SWITCHED ON AFTER A TEMPORARILY ABSENCE OF POWER SUPPLY, IT TAKES UNTIL 10 MINUTES TO RE-ESTABLISH THE RADIO TUNING
WITH THE RADIO SENSOR.
WAIT
10 sec.
1
1
2
3
4
5
6
Time = 1 Klux
Times = 8
= 15
= 22
= 30
= 45
Klux
Times Klux
Times Klux
Times Klux
Times Klux
08. Sun threshold adjusting.
PRESS BUTTON « » THE SAME TIMES
OF THE DESIRED THRESHOLD
FOLLOWING THE « »
TABLE
1
SUN THRESHOLD
THE NUMBER OF FLASHES
SIGNALS THE NEW
SET THRESHOLD.
PRESS AGAIN
BUTTON «2».
2
Flash
Flashes
Flashes
Flashes
Flashes
Flashes
= 1 Klux
= 8 Klux
= 15 Klux
= 22 Klux
= 30 Klux
= 45 Klux
THE LED FLASHES THE
SAME TIMES OF THE
CURRENTLY SET SUN
THRESHOLD.
Flash = 1 Klux
Flashes = 8 Klux
Flashes = 15 Klux
Flashes = 22 Klux
Flashes = 30 Klux
Flashes = 45 Klux
Flash
Flashes
Flashes
Flashes
Flashes
Flashes
= 10 Km/h
= 15 Km/h
= 20 Km/h
= 25 Km/h
= 30 Km/h
= 35 Km/h
THE RED LED FLASHES THE
SAME TIMES OF THE
CURRENTLY SET WIND
THRESHOLD.
HOLD BUTTON
FOR
2 seconds
«2»
2
PROG
«1»HOLD BUTTON
ON THE SENSOR
FOR AROUND 3 sec.

THE BATTERY USED ON THIS DEVICE HAS BEEN EXPRESSLY STUDIED FOR OUTSIDE USE. IT IS DANGEROUS AND FORBIDDEN
TO REPLACE THIS BATTERY WITH ONOTHER ONE WITH DIFFERENT TECHNICAL CHARACTERISTICS.
09. Power set.
12
PRESS TOGETHER BUTTON
« » AND « » ON THE SENSOR.
THE TWO LEDS FLASH ACCORDING
TO THE POWER SET.
1 2
3 Flashes = MAX CHARGE
+
-
+
-
+
-
+
-
3 = SPENT
REPLACE BATTERY
Flashes
YELLOW LED YELLOW LED YELLOW LED RED LED
The battery duration is estimate at least for 5 years on standard temperature and humidity conditions. However it must be considered that battery
duration can be shorter in particular use conditions. If it is available, it is strongly recommended to keep the “RADIO TEST” function active on the
tuned receiver. If the transmission range performed by the radio sensor, does not reach the tuned receiver anymore, due to the gradual battery
running out, the “RADIO TEST” of the receiver permits the roll up of the awning (around every 20 minutes) until it reaches the protection position
and gives a visible sign of the need to verify the radio sensor and, if it is the case, to replace the battery. While waiting for a specialized technician,
it is possible to temporarily deactivate the “RADIO TEST” following the receiver instruction guide.
10. Battery replacement.
The battery replacement must be carried out by qualified and authorized personnel, complying all the l
The battery must be replaced by one of the same type. Contact your dealer for the spent battery. Considering the sensor conditions of use, the inside temperature of the sensor
can be very high.An unsuitable battery may cause fire hazard or explosion danger.
Remove the bottom unscrewing the 3 fixing screws.
Shift the switch on the « » position.
Removed the spent battery and replace it with a new one respecting polarities.
Shift the switch on the « » position.
Replace the bottom of the sensor with the 3 fixing screws previously removed.
The spent battery must be dispose
If the system does not work, shift the switch on «OFF», waiting some second and
shift again the switch on «ON» verifying that the red led briefly lights, then verify again the sensor working. It is advisable to activate the
TO REPLACE BATTERY :
1.
2. OFF
3.
4. ON
5.
After battery replacement is compulsory verifying the correct working of the system.
aws in force in your locality.
on the proper containers, complying for the law in force in your locality.
«TEST RADIO» on the receivers if it has
been deactivated.
All products and technical characteristics on this document are subjects to variations without any notice.
MASTER declares that the device meets the principal requirements and the other regulations of the directive 1999/5/CE.
The declaration of conformity of the above products is available on the web site ,section «Conformity products»http://www.mastermotion.eu/it-IT/download
Notes.
2 Flashes = MEDIUM CHARGE 1 Flash = LOW CHARGE
.