Master OM BT01 User manual

Instructions for use
Product: Headphone
MODEL: OM BT01
Parameter
Support: A2DP, hands-free, ACVRCP profile
Input DC: 5V
Charging time : 2 hours
Call time: about 3 hours
Play time: about 3-4 hours
Impedance: 32 Ω
Bluetooth distance: 10m
Material: ABS + PVC
1. Turn On:
turn On the device and press the On button for 3 seconds, You will hear the voice
Power on, ready to pair, after the red light flashes, the white light turns on (every 0.5
seconds); after the pairing is successful, the white light turns on (every 3 minutes).
2. OFF:
when the device is turned on, hold the ON button for a longer period of time 3
seconds, You will hear the voice - Power off , The red light flashes and the rear light is
off.
3. Switch:
Press and hold for 3 seconds, power on to pair the connected device, or connect to a
new device, you will hear Single "Beep", the red light is on, and the white light is on
after the pairing is successful (every 3 minutes)
4. Pair new device
Press and hold for 4 seconds, power on to pair the new device, you will hear Single
"Beep", after the red light flashes, then the white light turns on (every 0.5 seconds);
after the pairing is successful, the white light turns on (every 3 minutes)
5. Play / Pause
Click the button, play: white light is on (every 3 minutes). Pause: white light is on
6. Connect the call, hang up
Click the button, the white light will turn on (every 3 minutes).

7. Reject the call
Long press for 3 seconds
8. Volume up/previous song
Volume up: click the button, you will hear Single "Beep"
Previous song: Long press the button for 3 seconds
Volume down/Next song
Volume down: click the button, you will hear Single "Beep"
Next song: Long press the button for 3 seconds
9. Low battery warning
If it is lower than 3.3V, it will be turned off after 2 reminders (every 3 minutes), the red
light will flash, you can hear the voice
10. Charge
Shut down, charge-red light is on during charging, white after full charge, etc.
11. Disconnect
After 5 minutes of disconnection, it will automatically shut down, the red light flashes,
and the back light is off.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this devic e must
accept any interference received, including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement