MasterView Read-out –User and Installation Manual
1 GENERAL INFORMATION
Use of this manual
This manual serves as a guideline for the safe
and effective operation of the MasterView
Read-out. Keep this manual at a secure place!
Warranty
Mastervolt assures the product warranty of the
MasterView Read-out during two years after
purchase, on the condition that the product is
installed and used according to the instructions
in this manual.
Installation or use not according to these
instructions may result in under performance,
damage or failure of the product and may void
this warranty. The warranty is limited to the cost
of repair and/or replacement of the product.
Costs of labour or shipping are not covered by
this warranty.
CAUTION!
Never remove the identification label.
This will void the warranty.
Liability
Mastervolt can accept no liability for:
•consequential damage due to use of the
MasterView Read-out;
•possible errors in the manuals and the
results thereof;
•use that is inconsistent with the purpose of
the product.
Disclaimer
Our products are subject to continual
development and improvement. Therefore,
additions or modifications to the products may
cause changes to the technical data and
functional specifications. No rights can be
derived from this document. Please consult our
online Terms & Conditions of Sale.
Correct disposal of this product
Please be informed about the local
separate collection system for electrical
and electronic products.
Please act according to your local rules and do
not dispose of your old products with your
normal household waste. The correct disposal
of your old product will help prevent potential
negative consequences to the environment and
human health.
2 INSTALLATION
What you need:
MasterView Read-out
MasterBus Terminator
ChargeMaster with MasterBus connections
(not included)
MasterBus connection cable (not included)
Installation:
Step 1. Disconnect the charger AC.
Step 2. Connect the Read-out panel to the
ChargeMaster, using (1) a MasterBus
cable and (2) two MasterBus
Terminators.
Step 3. Reconnect the charger AC.
The charger will recognize the Read-out and be
configured automatically to use this panel (Set
up automatic, see chapter 3).
MasterBus connections of the MasterView
Read-out, front and back side
