2
SAFETY INFORMATION
• Follow workshop health & safety rules,
regulations and conditions when using 50W
COB Rechargeable Floodlight with Bluetooth
Speaker.
• When not in use, COB rechargeable worklight
should be stored in a dry location to inhibit
rust.
• During their period of use, accessories must be
checked for wear, cracks and other damage,
replace any damaged or worn parts.
• Use genuine parts only. Unauthorized parts
may be dangerous and will void the warranty.
• Keep the COB rechargeable worklight clean
and in good working order for best and safest
performance.
• DO NOT use the lamp in the immediate vicinity
of inflammable materials or gases.
• DO NOT point the light directly in your own or
any other person’s or animal’s eyes.
• DO NOT drop, throw or abuse the COB
Rechargeable worklight.
• Eyes protection: Wear a protective mask or
protective eyewear.
• Check that the product has not suered any
damage during transport or storage. Clean and
remove any dust or residual packing material.
• Read the instructions carefully before using
COB Rechargeable worklight and keep them
for further reference.
WARNING!
• DO NOT immerse COB rechargeable worklight
in water.
• DO NOT place COB rechargeable worklight
near a fire or any other source of intense heat.
• DO NOT attempt to open, disassemble, modify
or service the worklight.
• DO NOT expose COB rechargeable worklight
to temperatures above 50°C (122° F).
• DO NOT use COB rechargeable worklight if
you suspect that the batteries or the casing is
damaged
PACKAGING CONTENT
DESCRIPTION QTY.
COB Rechargeable Worklight 1
Power Cable with Adaptor 1
O.I.P.M. 1
OPERATING INSTALLATION
1. 5 LED indicators at the back shows the
percentage charge in the worklight.
2. Fully charge the battery before the first use. To
charge, connect the worklight with the charger
cable provided with it. Connect the adaptor to
the power source.
3. While charging, the 4 LED indicators at the
back will blink continuously.
4. When the battery is fully charged, all the
indicator LEDs will stop blinking. Full charging
takes about 3.5 hours.
5. Press the power button located at the back of
the light
BUTTON PRESS LUMENS
1st Press 400
2nd Press 1000
3rd Press 2000
4th Press 4000
6. For bluetooth connection of worklight to
phone, press and hold the orange button for
switching on the Bluetooth of the worklight
and connect to “Audio Floodlight” from your
phone.
7. The worklight can also be used as power bank
for charging mobile devices.
MAINTENANCE
• Clean any dirt from the housing or the lens
immediately, since it could cause overheating.
• If required, clean with a dry or slightly moist
clean cloth. Do not use cleaners that contain
abrasives or solvents.
• When not in use, COB rechargeable worklight
should be stored in a dry location.
