Matelec FPC-12570 User manual

DOC: FS 12570 REVISED: 140113
HYDROSTATIC PRESSURE TRANSDUCER
FPC-12570
Functional Overview
39mm
93mm 19mm 28mm
25mm
7.4mm
- Pressure Range: 0-1bar (0-10m)
- Small body diameter - 39mm
- Excellent repeatability and long term stability
- Excellent anti-interference ability
- Application: depth or level measurement in wells, open water
and ground water level measurement
Features
Dimensions
Thank you for purchasing the MATelec Hydrostatic Pressure Transducer.
This unit is designed to be used for both potable/raw/rain water and waste
water applications. The unit is suited to 4-20mA applications where precise
level readings are required.
Pressure Range: Gauge pressure: 0-1bar (0-10m)
Level Range: 0m-200m (site dependent)
Overload Pressure: 1.5 times full scale
Accuracy: 0.5% F.S
Supply Voltage: 12~30Vdc ; 24Vdc
Output Signals: 4~20mA
Temperature Ranges: Compensated Temperature: 0~50°C
Media: -10~70°C
Environment: -30~85°C
Storage: -40~125°C
Temperature Compensation: 0.02%F.S./°C
Electrical Connection: Vented Cable
Protection Classication: Sensor is IP68
Vibration: 20g ; 20~5000HZ
Housing Material: 316 Stainless Steel
Operating Life: >1x108Pressure Cycles
Specications
MATelec reserves the right to alter any technical data without notice.
®
ATelec
AUSTRALIA

DOC: FS 12570 REVISED: 140113
HYDROSTATIC PRESSURE TRANSDUCER
FPC-12570
Installation Guide
MATelec reserves the right to alter any technical data without notice.
100mm
(MIN)
50mm
(MIN)
1 2 3 45
Installing a Hydrostatic Transducer | FSW-12570
OPEN OPEN
Hanging
Point
Nylon
Clamp
CLOSE CLOSE
100mm
(MIN)
50mm
(MIN)
1 2 3 45
Installing a Hydrostatic Transducer | FSW-12570
OPEN OPEN
Hanging
Point
Nylon
Clamp
CLOSE CLOSE
100mm
(MIN)
50mm
(MIN)
1 2 3 45
Installing a Hydrostatic Transducer | FSW-12570
OPEN OPEN
Hanging
Point
Nylon
Clamp
CLOSE CLOSE
100mm
(MIN)
50mm
(MIN)
1 2 3 45
Installing a Hydrostatic Transducer | FSW-12570
OPEN OPEN
Hanging
Point
Nylon
Clamp
CLOSE CLOSE
100mm
(MIN)
50mm
(MIN)
1 2 3 45
Installing a Hydrostatic Transducer | FSW-12570
OPEN OPEN
Hanging
Point
Nylon
Clamp
CLOSE CLOSE
1. Ensure hook or similar bracket
(supplied by others) is installed, for
clamp to hang from.
2. Move nylon clamps up to enable
Cable Receptor to open.
3. Place cable in clamp
ensuring it is aligned
with cable groove.
4. Move clamps down to ensure
cable is securely held/clamped.
Care must be taken to ensure
Transducer position is correct.
(Refer Fig. 5)
5. Hang bracket on hook.
The weight of the transducer will ensure the clamps
continue to hold the cable.
Excess cable must be coiled neatly ensuring no kinks
obstruct internal Air Tube.
®
ATelec
AUSTRALIA