Matheo MVC 141 BK User manual
MVC 141
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.10
.11
.12
.13
.14
.15
.
.
.
.
.
.
.
MVC 141
Dear customer!
Thanks for your worthful choce and confdence to Feller
brand. We really hope that you enjoy operatng ths product.
English
Safety directions
1.For the rst operation, it is advisable to read the manual carefully before
hand and keep it properly for future use.
2.Before the rst operation, make sure the dust cup or the dust bag is
properly installed.
3.Make sure the power supply is 220-240V~ 50Hz
4.Do not vacuum water and inammable material.
5.Do not vacuum burning material and ashes.
6.Do not use the machine without a motor protection lter lled.
7.Please change the dust bag immediately when it was damaged.
8.Do not store or use the machine close to high temperature places.
9.Dot not let children use the machine in case of danger.
10.If abnormal noise, smell, smoke or any other failure or breakage is found
during the operation, you should turn o the switch and unplug it.Then
contact with your service center for repair. Do not repair by yourself.
11.If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualied person in order to avoid a
hazard.
12.This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
13.Children should be supervised to ensure that they do not play with the
appliance.
14.The plug must be removed from the power socket before any
maintenance or replacement. 1
Correct Disposal of this product
Failure clearance
This marking indicates that this product should not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the
return and collection systems or contact the retailer where
the product was purchased.They can take this product for
environmental safe recycling.
1. Less vacuum power of the cleaner
2. The cleaner can be used as tip the rubbish out of the full dust cup or the
dust bag.
3. If blockage is found in ground brush, hose or tubes, the machine can be
re-operated only after the blockage is cleared away.
Warning
The plug must be removed from the power socket before any maintenance
or replacement.
If the power cord is damaged, replace them only by the factory or
maintenance center or similarly qualied persons.
2
Introduction of Product
MVC 141 vacuum cleaner of clear lines and structure can produce
centralized wind with less noise, adjust the operation speed, indicate full
dust, and automatically rewind the wire, multi-level lter exchange, dust
cup and dust bag two in one. Being convenient and exible in cleaning
dust, it is reliable and ideal household cleaning tool.
1. Big wheel
2. Power cord
3. ON/OFF switch pedal
4.The outlet board cover
5. Speed control button
6. Cord rewinding pedal
7. Dust full indicator
8. Front cover
9. Lock clip
Welcome to purchase and use our products.
Attached list
A set of hose accessories, 2pcs plastic tube, one oor brush, one integrated
brush
1
2
3
4
6
5
7
8
9
3
Operation methods
1. Connect the hose accessories: insert the hose end into the hose socket
at the front cover and then hook it. (Fig1)
2. Remove the hose accessories: press the adaptors at both side of the
hose end and then pull the hose accessories. (Fig2)
3. Connect the plastic tube to the curves end of the hose. (Fig3)
4. Connect dierent nozzle tools to the tube for dierent cleaning
purpose: oor brush (adjust to the type of ground) for carpet or oor
(Fig4,5); combine brush & nozzle for sofa, wall surface, curtain, corner or
space between furniture and etc. (Fig6)
5. Turn on the machine: insert the plug of cord into the power socket
which conform to that on the label for power supply, and press the on/o
switch pedal, the machine could start working (Fig7).
6. Cord rewinding: hold the plug and pull out the cord; press the cord
rewinding pedal, that power cord will be drawn in.(Fig8)
123
4
7 8
5 6
4
Maintenance
1. Change the dust bag: when the wind indicator turns to be red, it is time
to clear the dust or replace with a new bag. (Fig 1)
2. Open the front cover by clipping. (Fig 2)
3. Take out the bag then remove the full dust bag. (Fig 3)
4. Exchange the outlet lter: clip down and remove the outlet cover by
hands for exchange of lter. (g 4,5,)
5. The motor protection lter should be cleaned or exchanged after it is
dirt. (Fig6)
1
4
2
5
3
6
5
Table of contents
Languages:
