Matoha PlasTell User manual

Quick reference
guide
Safety information
Please read the safety section in the user manual before using
the device.
Keep device away from
liquids
If any issue occurs, stop using
the device and inform your
supervisor (or Matoha).
Do not touch the sensor
surface
Use a clean, dry cloth to
clean the sensor if dirty
Using the App
1. Connect to the device 2. Scan & select your machine
3. Choose ‘Measurement
interface’
4. Scan your sample and select
the collection to save into (ask
your supervisor).
Device name/number
✓
✗
🤢
5. Add sample information
such as the material.
6. Press Save. Hold Save if the
garment is the same as the
measurement before to pair
them (add to previous).
✗

Instrument parts & operation
Turn on: plug in the power cable Turn off: unplug the power
cable. When starting, the device will say “Calibrating”. DO NOT
place any samples onto the sensor until the device shows
“Ready”.
Measuring DOs and DON’Ts
✓
DO push the sample
onto the device and wait
✗
DON’T move the sample
while scanning
✗
DON’T cover samples with
your hand
✗
✗
DON’T scan printed
areas or labels.
✓
✗
For further help, please refer to the User Manual or e-mail us at
[email protected] © 2021 Matoha Instrumentation Ltd.
Wi-Fi
connected
Plastic composition
Updates available –Please update device
Identification confidence
WAIT
Screen
✓
DO cover the detector fully. If the sample is too small,
place it on the right-hand side.
Control
Button
Sensor
Material
indicator
Screen
Power
connector
(Device number
underneath)
✗✓✓
✓