maxon motor ADS_E 50/10 User manual





...........................................................................................................................................2
...........................................................................................................................................3
............................................................................4
.....................................................................................................................................5
.........................................................................................................................................................7
...................................................................................................................10
...............................................................................................................................12
...............................................................................................................................................13
9EMC-compliant installation............................................................................................................................13
10 Block Circuit Diagram....................................................................................................................................14
..................................................................................14
.......................................................................................................................................15
..................................................................................................................15

2
Skilled Personnel
Installation and starting of the equipment shall only be performed by experienced, skilled
personnel.
Statutory Regulations
The user must ensure that the servoamplifier and the components belonging to it are
assembled and connected according to local statutory regulations.
Load Disconnected
For primary operation the motor should be free running, i.e. with the load disconnected.
Additional Safety Equipment
An electronic apparatus is not fail-safe in principle. Machines and apparatus must there-
fore be fitted with independent monitoring and safety equipment. If the equipment breaks
down, if it is operated incorrectly, if the control unit breaks down or if the cables break,
etc., it must be ensured, that the drive or the complete apparatus is kept in a safe
operating mode.
Repairs
Repairs may be made by authorised personnel only or by the manufacturer. It is
dangerous for the user to open the unit or make repairs to it.
Danger
Do ensure that during the installation of the ADS_E 50/10 no apparatus is connected to
the electrical supply. After switching on, do not touch any live parts.
Maximum Supply Voltage
Make sure that the supply voltage is between 12 and 50 VDC. Voltages higher than
53 VDC or of wrong polarity will destroy the unit.
Short circuit and earth fault
The ADS_E 50/10 amplifier is not protected against winding short circuits against ground
safety earth or Gnd!
   
     
3
075.0
1
15.0
mHL
mH
mAI
s
VV
mHLMotor
D
CC
extern 













May 2013 Edition / subject to change maxon motor control 3






≤


4 maxon motor control May 2013 Edition / subject to change

May 2013 Edition / subject to change maxon motor control 5




 

 
VM
M
n
n
n
U
VBB
N
CC 2
9.01
0













6 maxon motor control May 2013 Edition / subject to change



May 2013 Edition / subject to change maxon motor control 7









8 maxon motor control May 2013 Edition / subject to change



May 2013 Edition / subject to change maxon motor control 9
≤

10 maxon motor control May 2013 Edition / subject to change



May 2013 Edition / subject to change maxon motor control 11




12 maxon motor control May 2013 Edition / subject to change
7.1 No LED




7.2 LED shines green
7.3 LED shines red




If the input frequency at the encoder
input is > 150 kHz, the power amplifier is
switched off.





May 2013 Edition / subject to change maxon motor control 13
9 EMC-compliant installation













14 maxon motor control May 2013 Edition / subject to change
10 Block Circuit Diagram

May 2013 Edition / subject to change maxon motor control 15
128.4
35.2 2.5
maxon motor

16 maxon motor control May 2013 Edition / subject to change