Step 1:
•Tip both side frames onto front (with wheel attachment off the ground as shown below).
•Loosely bolt front crossbar to both side frames with 4x M12x30mm bolts and washers as
shown below. Note: he front crossbar (only crossbar with band edge for attaching net)
should be lying on the ground with the band edge facing towards the rear of the goal.
•Attach rear crossbar loosely with 4x M12x30mm bolts and washers.
•Once both crossbars are attached tighten all 8 bolts firmly with 8mm Allen Key provided.
Step 2:
•Flip hockey goal back to normal position as shown in diagram below.
•Move backboard into position at the rear of the goal and in line with the bolt holes in the
side frames. Note: Make sure backboard is up the right way with hooks pointing
downwards at the back of the backboard (so the net can be secured later).
•Loosely bolt the side frames to the backboard with 3x M12x90mm bolts and washers at each
end of the backboard. Note: ake care to ensure the backboard is lined up correctly with
both side stands before inserting bolts.
•Once the backboard is attached tighten all 6 bolts firmly with 8mm Allen Key provided.
