
Step 1: Determine the ideal location where you would like to install your vanity.
Step 2-3: Place the vanity in the installation location. Verify that the vanity cabinet is level.
If the vanity is not level, adjust the feet.
To lower the cabinet, turn feet clockwise. To raise the cabinet, turn feet counter clockwise.
Step 1: Apply a small bead of silicone sealant around
the top edge of the vanity cabinet (see Fig 1).
Step 2: With assistance from another person, slowly
and carefully set the vanity top onto the vanity
cabinet. Once positioned, press firmly into place.
Wipe away any excess sealant using a damp cloth.
Step 3: Apply a generous amount of silicone sealant
on the back and bottom of the back-splash. Press
firmly the back-splash into place against your
bathroom wall (see Fig 2).
Fill any gaps that are left with silicone sealant. Wipe
away any excess sealant with a damp cloth.
Step 4: Let the assembled vanity sit for 24 hours to
allow all the silicone sealant to fully dry. Once dry,
proceed to the installation of your faucet and drain.
CABINET INSTALLATION
VANITY TOP AND SINK INSTALLATION
REV.10192018INSTALLATIONGUIDE www.maykke.com
INSTALLATION GUIDE
Fig 1
Fig 2
IMPORTANT:
The vanity top is pre-installed with the sink.
The vanity top is very fragile. Take caution when handling, and have someone assist you.