
SYSTEM OPERATION
12
•
minutes. This feature is enabled in standard or remote
thermostat control.
•
changed during the four minutes this lock in feature is
•
•
•
manufacturer may not work correctly with this unit.
• Remote Functions - All functions are controlled by a
wall mounted thermostat.
• Remote Fan - When GL terminal is connected to R
switched to high.
•
in standard mode if the fuse is blown. There will be
• Random Delay - When the master switch is turned on
closed for more than two seconds, or the mode switch
• Indoor Ambient Thermistor - The Indoor Ambient
•
20 minutes and the Indoor Coil Thermistor is below 30
• Load Shedding - The IN & COM terminals are used
for load shedding. A switch can be added to close the
•
the cooling mode. This routine runs the unit fan on
• Front Desk Control - The front desk control terminals
• Transfer Fan - A transfer fan may be used if a user
• Emergency Hydronic Heat - A switch can be added
to the IN & COM terminals to close the circuit to
enable the fan, enable the heater relay and lockout
The unit will be controlled by a Wired Wall Thermostat or
the Amana Wireless Thermostat.