PERFORMANCE SPECIFICATIONS
2
1. The heavy lines on the schematic denote the primary
signal path.
2. Unless otherwise noted, all voltages indicated on the
schematics are measured under the following conditions:
a. AC input at 120 volts, 50/60Hz.
b. All voltages are +/-10% with respect to ground. A
high impedance (10 megaohm) voltmeter must be used.
3. Unless otherwise specified:
a. Resistor values are in ohms.
b. Capacitor values are microfarads (uF).
c. Inductor values are in microhenries (uH).
4. On PC board drawings, Square pad indicates:
a. Polarized Capacitors - Positive
b. Diodes - Cathode
c. Others - Pin 1
5. WARNING
Parts marked with the symbol have critical
characteristics. Use only replacement parts recom-
mended by the manufacturer.
NOTES
PowerOutput
Minimum sine wave continuous average power output per
channel, both channels operating is:
100 watts into 2 ohm load
100 watts into 4 ohm load
100 watts into 8 ohm load
PowerOutputMonoParallel
Miniumum sine wave continuous average power output is:
200 watts into 1 ohm, 2 ohm or 4 ohm load
PowerOutputMonoBridge
Miniumum sine wave continuous average power output is:
200 watts into 4 ohm, 8 ohm or 16 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power level
from 250 milliwatts to rated power output is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 70,000Hz
Sensitivity
2.5 Volts Unbalanced Input
5 Volts Balanced Input
A-WeightedSignalTo NoiseRatio
100dB
IntermodulationDistortion
Maximum Intermodulation Distortion if instantaneous
peak output does not exceed twice the rated output,
for any combination of frequencies from 20Hz to
20,000Hz is:
0.5% for 2, 4 or 8 ohm loads (Stereo)
0.5% for 1, 2 or 4 ohm loads (Mono Parallel)
0.5% for 4, 8 or 16 ohm loads (Mono Bridge)
InputImpedance
20,000 ohms Unbalanced Inputs
40,000 ohms Balanced Inputs
Wide Band Damping Factor
Greater than 18
Power Requirements
100 Volts ~, 50/60Hz at 6.0 amps
110 Volts ~, 50/60Hz at 5.5 amps
120 Volts ~, 50/60Hz at 5.0 amps
220 Volts ~, 50/60Hz at 2.5 amps
230 Volts ~, 50/60Hz at 2.5 amps
240 Volts ~, 50/60Hz at 2.5 amps
Note: Refer to the rear panel of the MC2102 for the correct
voltage.
Dimensions
Front Panel: 17-3/4 inches (45.08cm) wide, 10-1/8 inches
(25.72cm) high. Depth behind front mounting panel is 16
inches (40.64cm). Clearance required in front of the Front
Panel is 1 inches (2.54cm) for knobs.
Weight
88 pounds (40kg) net, 121 pounds (54.9kg) in shipping carton
