MCS MCS-WIRELESS-MODEM-B User manual

MCS-WIRELESS-MODEM-B - MCS-WIRELESS-MODEM-INT-B
QUICK START SETUP
1. WIRING MCS-WIRELESS-MODEM-B (or MCS-WIRELSS-MODEM-INT-B)
MCS-WIRELESS MODEM-B / INT-B ships as shown, use power plug or cut o󰀨 plug and wire to a
12 volt power supply (not included).
1. If using a 12 volt power supply, cut the wire at the plug end, exposing the red and black
wires.
2. Connect the red wire to the +V connection of the power and black to the -V connection.
DUAL BAND ANTENNA
MCS recommends using the DUAL BAND ANTENNA BOOSTER for better reception.
Attach the Dual Band Antenna, thumb tight only to Mobile Main Antenna connection.
2. CONNECT TO THE MCS-MAGNUM
Connect the Crossover orange CATS 5 cable from MCS-WIRELESS-MODEM-B to the Ethernet
port on the MAGNUM and the other end of the cable to the LAN port on the MCS-WIRELESS-MODEM-B
or MCS-WIRELESS-INT-B.
MCS
POWER
SUPPLY
WIFI
MOBILE
AUX
MOBILE
MAIN
Dual Band Antenna Booster
Reset button
WiFi antenna
connector Mobile AUX antenna connector
Mobile Main
antenna connector
Ethernet Crossover
Cable supplied
ETHERNET
PORT
Power socket
Mobile signal
strength indication
LEDs
Mobile network
type LEDs LAN port WAN port
Power LED SIM holder LAN LED WAN LED

3. HARDWARE INSTALLATION
1. Push the SIM button with the SIM needle supplied.
2. Pull out the SIM holder.
3. Insert your SIM card into the SIM holder. (SIM card is not supplied, check with MCS for the
phone carrier for your area that can be used for these modems. The SIM card must have
Data and SMS)
4. Slide the SIM holder back into the router.
5. Attach Dual Band Antenna or Mobile and WiFi antennas, depending on installation.
6. Connect the power adapter to the socket on the front of the device. Then plug the other end of the
power adapter into a power outlet.
Note: MCS-WIRELESS-MODEM-B or MCS-WIRELESS-MODEM-INT-B can be powered using
a 12vdc power supply (see wiring).
7. Use the supplied Din Rail mounting kit if installing in an enclosure.
4. NETWORK ADDRESS ON MCS-MAGNUM
THE IP ADDRESS FOR YOUR NEW MCS-WIRELESS-MODEM-B HAS BEEN FACTORY SET
AND IS SUPPLIED WITH THE UNIT ON THE LABEL OF THE MODEM.
YOU MUST SET THE NETWORK ADDRESS ON YOUR CONTROLLER TO MATCH THIS FACTORY
ADDRESS.
5. INSTALL OPEN VPN client on your machine
1. Open a browser on your computer, and go to the link below.
https://openvpn.net/vpn-client/
2. Download the VPN CLIENT and install on your computer.
3. Attach the USB drive, that was included.
4. Open the USB drive, drop or drag the supplied le into this
window.
Connect to multiple MAGNUMS using an Ethernet SWITCH
(Each MAGNUM must have a unique address.)

5. Open MCS-CONNECT on your computer.
6. Click on ‘SETUP’ > ‘NETWORK OPTIONS’
7. MCS-Connect will show a new device in the Network Options screen.
8. Look for the one that says ‘OpenVPN’, and select it.
9. Now try to connect to the Magnum over Remote Ethernet with the settings below.
MCS-WIRELESS-B-REV 1.6. - December 7, 2022 3:16 PM