MD SPORTS 1639634 User manual

TM
MODEL:1639634
VM Innovations
ASSEMBLY INSTRUCTIONS
ATTENTION
DO NOT RETURN
TO THE STORE
Contact
MD Sports
Customer Service
* For additional resources and Frequently
Ask Questions, please visit us at
themdsports.com

www.themdsports.com
1639634 1
(Continued on the next page.)
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If,
during the limited warranty period, a part is found to be defective or breaks, we will offer replacement part
at no cost to you, the customer. The only exceptions to the warranty include main frames, table tops,
playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse,
accidental damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights which vary from
one State (province) to another.
A PURCHASE RECEIPT (or other proof of purchase date) will be required before any warranty service is
initiated. All requests for warranty service, please feel free to contact our Consumer Service Department at :
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal
Sports, can not handle the product which is out of product’s limited warranty since we only provide available
parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING
THE PRODUCT TO THE STORE.
WEBSITE: www.themdsports.com
NOTICE!
STAPLE YOUR RECEIPT HERE
1 - Please leave your name, address, phone number, model number, parts needed on the answering
machine if there is no attendant. Failure to do so will result in a delay in shipping parts to you.
2 - Please review the replacement parts list and make sure that you have all your parts before beginning
assembly. For questions that may arise or for missing/damaged parts, please contact us.
3 - Since you build all tables upside down, please inspect tabletops or playing surfaces right away before
putting together, all damaged table tops/playing surfaces need to be returned to the store. Please
contact with retailer for their return policy.
LIMITED 90 DAYS WARRANTY

www.themdsports.com
1639634 2
(Continued on the next page.)
X4
Strong Adults Needed No Children in
Assembly Area
Keep away from pets Do not use or keep product
outdoors. For indoor use only.
No wet/humid conditions.
Power Tools
- Set Low Torque
High Torque
over tightened
TOOLS REQUIRED:
Phillips Screwdriver - Not Included
Standard (Flat Head Screwdriver) - Not Included
Wrench - Included
Allen Key - Included
CAUTION !
Electric Screwdrivers may be helpful during assembly;
however, please set a low torque and use extreme
caution.
WARNING:


!
WARNING: Adult Assembly Required.
!
ASSEMBLY TIPS:
1 - Please read the instructions carefully, and follow all assembly, operation or safety instructions properly in order to
avoid damage or injury. For the assembly, at least two adults are required.
2 - Some figures or drawings may not look exactly like your product. Please read and understand the text before
beginning each assembly step.
1 - This product is intended for INDOOR use only.
2 - Please Do Not sit, climb or lean on the product.
3 - Please Do Not drag the table when moving it in order to avoid the damaged on the legs.
4 - Please only use spray furniture polish to clean the exterior surfaces on the product.
5 - This is not a child's toy, adult supervision is required for children playing this game.
IMPORTANT NOTICE!

www.themdsports.com
1639634 3
(Continued on the next page.)
Lower Side Apron Lower End Apron Apron Corner
Support Board
2-1/4” Billiard Ball Set 2-1/4” Triangle Chalk
End Top Board
910 11 12
13 14 15 16
Glue Wrench
“U” Plastic Bracket57” Cue
Leg Shim Side Top Board
2 3 4
Mainframe
1
x1 x4 x9 x2
6 7 85
x2 x2 x4
x2 x1 x1 x2
x2 x4 x1 x1
x2
Allen Key
18 19 20
5/16” Washer
5/16”x1-1/2” Bolt F4x1-1/2” Screw
x16 x16 x18
17
x1
1/4”x1” Bolt
22 23 24
1/4”x 1-1/2” Bolt
T4x5/8” Screw 1/4” Washer
x20 x4 x4
21
x18
1/4” Nut
26
T4x1/2” Screw
x8
25
x4
1639634 PARTS LIST
27
Brush
x1

1. Find a clean, level place to begin the assembly of your Billiard Table. The table will be assembled upside down
and then turned over on its legs once the assembly is completed. This game table is heavy, and turning it over
will require at least four strong adults.
2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list
pages. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your
work surface.
ASSEMBLY INSTRUCTIONS:
www.themdsports.com
1639634 4
(Continued on the next page.)
1639634 PRE-INSTALLED PARTS
F5x2-1/2” Screw Corner PocketAdjustable “L” Bracket
P1 P2
x16 x2 x4
P3
Side Pocket
P4
x2
5/16” Nut
P5 P6
x16
Leg Top Board
x4
FIG.1
3. Apply the Glue (#15) into the grooves of the Side and End Top Boards (#4 and #6). See FIG. 1A.
4. Reverse the Side Top Boards (#4) and attach to the Lower Side Aprons (#5) using six Screws (#20) per Side
Top Board. See FIG. 1.
5. Reverse the End Top Boards (#6) and attach to the Lower End Aprons (#7) using three Screws (#20) per End
Top Board. See FIG. 1.
FIG. 1
4
5
6
7
15
X 2
X 2
X 2
X 2
X 1
20
X 18
15
20
6
7
4 6
/
20
4
5
FIG. 1A

www.themdsports.com
1639634 5
(Continued on the next page.)
FIG.2
6. Align the Lower Side and End Aprons with Top Boards (pre-assembled, See FIG. 1) as shown in FIG. 2. Slide the
Apron Corners (#8) onto the Lower Side and End aprons (#5 and #7) and then attach it using two Screws (#26)
per Apron Corner.
FIG. 2
8
26
X 4
X 8
NOTE: Arrow on backside of corner brace shows direction to
slide corner brace down.
5
5
7
7
8
5
7
Top View: part #8 Side View: part #8
8
8
7
NOTE: Flush with Aprons
5
5
8
7
7
26
5

www.themdsports.com
1639634 6
(Continued on the next page.)
FIG.3
7. Attach the Legs (#2) to the Lower Side and End Aprons (#5 and #7) using four Bolts (#18) and four Washers (#19)
per Leg. See FIG. 3 and 3A.
FIG. 3
2
18
19
X 4
X 16
X 16
X 16
P1
P5
P6
X 16
X 4
FIG.4
8. Attach the “U” Plastic Brackets (#14) to the Support Boards (#9) using one Bolt (#23), one Washer (#24) and one
Nut (#25) per “U” Plastic Bracket. See FIG. 4.
FIG. 4
24
23
14
9
X 2
X 4
X 4
X 4
25
X 4
X 2
P2
5
18
5
7
7
2
P5 P6
2
P1
2
FIG. 3A
19
23
25
24
14
9
P2

www.themdsports.com
1639634 7
(Continued on the next page.)
DO NOT LEAN THE
TABLE ON ITS LEGS
HOLD TABLE
HOLD TABLE DO NOT HOLD THE LEGS
CAUTION: Four strong adults are recommended to turn
the table over as shown.
1. Lift the table off of the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
FIG.5
9. Lift the Lower Aprons/Legs assembly (See FIG. 3) from the floor with four strong adults, turn it over, and set the
table on its legs in the location where you will play.
10. Place the Support Boards (#9) between the Lower Side Aprons (#5) as shown in FIG. 5. Attach the “U” Plastic
Brackets (#14) to the Lower Side Aprons (#5) using four Screws (#22) per “U” Plastic Bracket.
Please note the Adjustable “L” Brackets (P2) and the Support Boards (#9) must be parallel as shown
in FIG. 6A.
FIG. 5
22
X 16
9
9
5
22
14
5
9
P2
P2
Notice: Adjust the playfield level.
FIG. 5A

www.themdsports.com
1639634 8
(Continued on the next page.)
FIG.6
1
X 1
22
X 4
21
X 18
FIG.6
11. Place the Mainframe (#1) on the top of the pre-assembled Lower Table assembly (See FIG. 5). Underneath the
Mainframe (#1), assemble the Mainframe (#1) to the Side and End Top Boards (#4 and #6) using eighteen bolts
(#21). See FIG. 6A and 6B.
12. Attach the Adjustable "L" Brackets (#P2) to the backside of the Mainframe (#1) using two screws (#22) per
Adjustable "L" Bracket. See FIG. 6B.
Go back and make sure that all connections are tight.
22
21
6
1
7
9
5
4
1
FIG. 6A
FIG. 6C P2
1
1
FIG. 6B

www.themdsports.com
1639634 9
(The last page)
FIG.7
13. Under the Mainframe (#1), adjust the Adjustable "L" Brackets (#P2) in order to level the playfield of the
Mainframe (#1). See FIG. 7A and 7B.
FIG.7
Note: Utilize shims (#3) if
needed (as shown) to level
the table.
16
X 1
3
X 9
P3
X 4
P4
X 2
16
FIG. 7A
P2
16
1
3
FIG. 7B
P2
P3
P4
YOU ARE NOW READY TO PLAY!
NOTE: DO NOT lift the table by the pockets.
If you move the table, do not lift it by placing
your hands beneath the pockets and do not
lean or put pressure on them. Do not lean
or sit on the end or side rails as this may
damage the table.