MD SPORTS AC284Y22010 User manual

MODEL
AC284Y22010
www.medalsports.com877-472-4296
Assembly Instructions

This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
MD SPORTS
877-472-4296
www.medalsports.com
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP
AC284Y22010 1(Continued on the next page) www.medalsports.com
English
LIMITED 90 DAYS WARRANTY

This product is intended for INDOOR use only.
Please do not sit, climb or lean on the product.
Please do not drag the product when moving it in order to avoid damaging the legs.
Please only use furniture polish spray to clean the exterior surfaces of the product.
Adult supervision is required for children playing this game.
1.
2.
3.
4.
5.
- Not Included
- Not Included
- Included
RECOMMENDED
IMPORTANT NOTICE
Phillips Screwdriver
Standard (Flat Head Screwdriver)
Allen Key
Electric Screwdrivers may be helpful during assembly; however, please set a low
torque and use extreme caution.
X2
At least 2 adults needed No children in assembly
area
Keep away from pets in
assembly area
Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
Power Tools: Set to Low Torque
High Torque Over Tightened
AC284Y22010 2(Continued on the next page) www.medalsports.comAC284Y22010 2(Continued on the next page) www.medalsports.com
English
TOOLS REQUIRED
Adult assembly required.
CHOKING HAZARD - This item contains small parts. Not suitable for children under 3 years.
WARNING

PART NUMBER FIG. NUMBER
QUANTITY
PART
PART NAME
1
x1
FOR FIG. 19
AC284Y22010 3(Continued on the next page) www.medalsports.com
English
PARTS IDENTIFIER
Bottom Board
Ball Return Board - A Ball Return Board - B
Back Board Side Apron - A
Goal Box Board
Connecting Board
Playfield
Glue
Complementary Plate
Side Apron - C Side Apron - With Control Switch
Playfield With LED
Side Apron - B
Top Panel
Support Board - D
Target Board With Sensor
Support Board - A
Support Board - B
“L” Bracket
Support Board - C
Leg - A
Leg - C Leg - D
Leg - B
End Apron
End Leg Panel - A
End Leg Panel - B
3
x1
FOR FIG. 16
2
x1
FOR FIG. 17 4
x1
FOR FIG. 16 5
x1
FOR FIG. 18
6
x1
FOR FIG. 16 7
x1
FOR FIG. 16 8
x1
FOR FIG. 4 9
x1
FOR FIG. 8
11
x1
FOR FIG. 17
10
x1
FOR FIG. 20 12
x1
FOR FIG. 4 13
x1
FOR FIG. 4
14
x1
FOR FIG. 1 15
x1
FOR FIG. 1 16
x1
FOR FIG. 1 17
x1
FOR FIG. 3
19
x1
FOR FIG. 2
18
x1
FOR FIG. 2 20
x1
FOR FIG. 2 21
x1
FOR FIG. 21
22
x2
FOR FIG. 13 23
x1
FOR FIG. 8 24
x2
FOR FIG. 6 25
x1
FOR FIG. 5
27
x1
FOR FIG. 13
26
x1
FOR FIG. 13 28
x2
FOR FIG. 12 29
x1
FOR FIG. 8
Left Back Panel

ACCESSORIES
HARDWARE
PRE-INSTALLED PARTS
Right Back Panel Electronic Scorer
Ball
Support Board - E Metal Net
A1
A5
A10
A6 A7 A8
A2 A3 A4
3x25mm Screw 3x30mm Screw4x35mm Screw
4x45mm Screw M6x22mm Bolt M6 Washer
4x15mm Screw
M6x28mm Butterfly Bolt
A9
x2
FOR FIG. 4
FOR FIG. 2
FOR FIG. 22
FOR FIG. 3, 11, 16 FOR FIG. 3, 11, 16
FOR FIG. 1, 2, 4, 14, 19
FOR FIG. 3, 6, 7, 10
FOR FIG. 5, 8, 18 FOR FIG. 9, 13 FOR FIG. 2, 12, 17,
18, 20, 21
3x30mm Flat Head Screw
x14 x6 x42 x21
x14x14x2
x4
x16
Target Sensor Wire
LED M6 T - Nut Control Switch
P1 P2 P3 P4
FOR FIG. 8 FOR FIG. 1FOR FIG. 3, 6
x1 x16 x5 x1
A11
Allen Key
x1
4x12mm Screw
31
x1
FOR FIG. 9
30
x1
FOR FIG. 8 32
x2
FOR FIG. 18 33
x1
FOR FIG. 22
34
x3
AC284Y22010 4(Continued on the next page) www.medalsports.com
English
PARTS IDENTIFIER
/
/

ASSEMBLY
AC284Y22010 5(Continued on the next page) www.medalsports.com
English
BEFORE ASSEMBLY
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list pages. If any parts are missing, call our customer service.
1.
2.
FIG. 1
x1
15
14 x1
x1
P4
x6
A4
16 x1
Pre-installed
Wall
16
14
A4
P4
Wall
16
14 15
15
14
15
16
14
A4
/
/

AC284Y22010 6(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 2
18 x1
19 x1
x1
20
x8
A3
A4 x3
A6 x2
FIG. 1 Assembly
19
A3
18
A6
A4
Note: Black side is facing down.
18
20
20
15
14
19
19
18
20
19
Black inside
A3

AC284Y22010 7(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 2 Assembly
FIG. 3
17 x1
P2
A5
A5
x8
x4
Pre-installed
x1
A7
x1
A8
x1
A11
17
The Hole
17
A7
A8
P2

AC284Y22010 8(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 4
8x1
x1
12
x1
13
x6
A4
A4
x2
A9
A9
Wall
Wall
8
8
13
13
12
12

AC284Y22010 9(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 5
x4
A1
25
25
x1
FIG. 6
x4
24
24
x2
P2
P2
x8
A5
A5
A1
Pre-installed
24
The Hole
13
13
12
12

AC284Y22010 10(Continued on the next page) www.medalsports.com
English
ASSEMBLY
8
13
15
16
FIG. 6 Assembly
FIG. 3 Assembly
12
14
FIG. 7
A5 x4
A5
17

AC284Y22010 11(Continued on the next page) www.medalsports.com
English
ASSEMBLY
Pre-installed
P1 x1
29
29
x1
30
30
x1
A1
A1
x6
23
23
x1
9x1
FIG. 8
Note: Apply the glue (23) into the grooves of the
top panel (9).
9
P1
9
9

AC284Y22010 12(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 9
31 x1
P1
x2
A2
BOTTOM VIEW
9
31
A2
P1
31
9
31

AC284Y22010 13(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 10
x4
A5
FIG. 9 Assembly
FIG. 7 Assembly
A5
12
14
13
29
24
30
15

AC284Y22010 14(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 13
x1
22 x2
26 x1
FIG. 12
27
x4
A2
22
FIG. 11
x1
A7
x1
A8
x1
A11
x2
28
28
28
x4
A3
A3
26 27
&26 27
&
A2
A7
A8
8
12
14
13
15
17

AC284Y22010 15(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 14
x4
A4
26
25
27
27
27
17
27
26
26
20
26
26
17
22
A4

AC284Y22010 16(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 16
x1
x1
4
3
x1
x1
7
7
x12
A7 A7
x12
A8
x1
A11
FIG. 15
P4
6
6
4
3
A8

Note: Go back and make sure that all connections are tight.
Lift the table off the ground.
Turn the table over.
Place it on all feet at the same time on the ground.
1.
2.
3.
Two strong adults are recommended to turn over the table as shown.
CAUTION
DO NOT LEAN THE
TABLE ON ITS LEGS
DO NOT HOLD THE TABLE
BY THE LEGS
HOLD BY THE
TABLETOP
CABINET
AC284Y22010 17(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 17
x1
2
x1
11
x12
A3
2
11
A3 A3

AC284Y22010 18(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 18
x1
5
5
5
x2
32
32
x4
A1
Note: Black side facing up.
5
5
29
29
7
7
6
30
30 27
27
A3
A3 x4
A1
5

AC284Y22010 19(Continued on the next page) www.medalsports.com
English
ASSEMBLY
FIG. 19
x1
1
x2
A4
129
30
30
A4
1
8
8
1
8
P4
31