MD SPORTS YUS450 018M User manual

MODEL:YUS450_018M
Menards
ASSEMBLY INSTRUCTIONS
ATTENTION
Contact
MD Sports
Customer Service
DO NOT RETURN
TO THE STORE
* For additional resources and Frequently
Asked Questions, please visit us at
themdsports.com

www.themdsports.com
YUS450_018M 1
(Continued on the next page.)
1 - Please leave your name, address, phone number, model number, parts needed on the answering machine if there is no
attendant. Failure to do so will result in a delay in shipping parts to you.
2 - Please review the replacement parts list and make sure that you have all of your parts before beginning assembly. For
questions that may arise or for missing/damaged parts, please contact us.
NOTICE!
LIMITED 90 DAYS WARRANTY
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited warranty
period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer. The only exceptions
to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental damage or
neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights which vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all requests for
warranty service, please feel free to contact our Consumer Service Department at:
WEBSITE: www.themdsports.com
Please be aware of your product’s Limited Warranty for the return/refund policy from the store. We, at Medal Sports, cannot handle
the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING
THE PRODUCT TO THE STORE.
STAPLE YOUR RECEIPT HERE
ON/OFF

www.themdsports.com
YUS450_018M 2
(Continued on the next page.)
1 - This product is intended for INDOOR use only.
2 - Please do not sit, climb or lean on the product.
3 - Please only use spray furniture polish to clean the exterior surfaces of the product.
4 - This is not a child's toy, adult supervision is required for children playing this game.
1 - Please read the instructions carefully, and follow all assembly, operation, and safety instructions properly in order to avoid
damage or injury. For the assembly, at least two adults are required.
2 - Some figures or drawings may not look exactly like your product. Please read and understand the text before beginning each
assembly step.
WARNING:
Adult Assembly Required.
WARNING:

ASSEMBLY TIPS
IMPORTANT NOTICE!
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
CAUTION!
No Children in
Assembly Area Keep away from pets
Do not use or keep product
outdoors. For indoor use only.
No wet/humid conditions.
Strong Adults Needed
X2

YUS450_018M PRE-INSTALLED PARTS
P1 P2
x1 x1
FOR FIG. 1 FOR FIG. 1
2 31
x1 x2
FOR FIG. 1
www.themdsports.com
YUS450_018M 3
(Continued on the next page.)
x1
FOR FIG. 4
YUS450_018M PARTS LIST
Inlet CapInlet Cover
Vinyl PatchControl Box
Inflatable bag with sensors
Note: Inflatable bag with sensors (#1) is not available as a replacement part.
ON/OFF

www.themdsports.com
YUS450_018M 4
(Continued on the next page.)
SAFETY INSTRUCTION
WARNING
●Product must be assembled by an adult before use.
●Do not over-inflate.
●Not to be used as a floating device.
●This product is for youth use only, it is not intended for adult training.
Child Safety
● Not to be used by children without adult supervision.
●To reduce the risk of suffocation, drowning or serious personal injury:
- Adults must always stay within reach of children while playing.
- Keep product away from small children when it is not inflated.
Product Protection
●Play only in an open area away from sharp objects, with at least a clear space of 10ft (3m) around the product.
● Avoid contact with sharp objects or hot surfaces.
● Make sure that there are no sharp objects on your shoes which might cause damage to the product.
HOW TO USE REPAIR PATCH?
1. Deflate product.
2. Clean defective area.
3. Cut round or oval patch.
4. Remove paper backing.
5. Apply sticky film to repair area. Squeeze out all air bubbles.
6. Do not inflate the product until the patch has been fixed in place for at least 20 minutes.
10 (3m)
Target Bag
10 (3m)

1
P2
P1
www.themdsports.com
YUS450_018M 5
(Continued on the next page.)
Base
Fill the Base with water.
WATER
Inflation
DO NOT OVER
INFLATE
Cover nozzles
Target
Bag
CAUTION:
• Inflation using an air pump must be performed by an adult.
• Do not use a high pressure pump or a pump for car tire.
• The maximum air pressure for the Inflatable Target is 2.0 kPa.
• Check before each use and at regular intervals.
Target
Bag
Base
Neck
Diameter MAX: 18 inch
Diameter MAX: 13 inch
FIG. 2
X 1
P1
X 1
P2
X 1
1FIG. 1

www.themdsports.com
YUS450_018M 6
(Continued on the next page.)
Bag
Scoring
Sensor Wire
ON/OFF
Note: Connect the Scoring
Sensor Wire to the Control
Box, then put it in the bag.
ON/OFF
Control
Box
Control
Box
ON/OFF
2
8 pins
Scoring
Sensor Wire
FIG. 3
X 1
2
FIG. 4
ON/OFF

www.themdsports.com
YUS450_018M 7
YOU ARE NOW READY TO PLAY!
(The last page)
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
GAME DESCRIPTIONS:
1: Press the ON/OFF key to start the game (playing the boot sound, and 3 LED lights will light up for 3 seconds).
2: Game time is 2 minutes.
3: After the game starts, one of 3 LED lights will light up for 2 seconds randomly. (If it is not hit within 2 seconds, another LED light will light up
randomly).
4: After the game is over, click the ON/OFF key to restart the game.
NOTE: The game will automatically power off if it is left idle for 5 minutes. It is recommended that you turn off
the Control Box and take out the battery when not in use.
NOTE: Pressing the “ON/OFF” key at any point for three seconds will turn the game off.
Battery Installation
1. Using a Phillips Head Screwdriver (not included), remove the battery box cover on the back of the Control Box and install
2 new “AAA” batteries.
2. Replace the battery box cover using a Phillips Head Screwdriver (not included).
Reminder:
a. Batteries must be installed according to the correct polarization (+and -) required.
b. If the game will not be used for a long period of time, we recommend that the batteries should be removed.
c. Please clean the battery contacts and also those of the device prior to battery installation.
WARNING:
!
1) Requires 2 “AAA” baeries (not included).
2) Do not mix old and new baeries.
3) Do not mix alkaline, standard (carbon zinc), or
rechargeable (nickel-cadmium) baeries.
When “ON / OFF” is pressed once, it starts up, when pressed and held for 3 seconds, it shuts down.
Control Box Operation