MDF AM1 User manual

User’s manual
ANALOG MULTIEFFECT
AM1
http://www.mdfitaly.it
1
User’s manual
ANALOG MULTIEFFECT

2
SUMMARY
INTRODUCTION......................................................................................................................................3
FEATURES..............................................................................................................................................3
OPERATION............................................................................................................................................4
CONNECTIONS..........................................................................................................................................5
TECHNICAL SPECIFICATION ................................................................................................................6

3
INTRODUCTION
Playing with four analog pedals (overdrive, distortion,
horus and delay with whi h they form 80% of sound) no
more tap dan ing, you an program and re all sounds
with a single blow of foot is possible today.
Thanks to all analog ir uitry of the effe ts resulting hot
and highly defined sound, with no loss of nuan e and
harmoni s.
It is really simple and intuitive (there would not even need
the manual) to dedi ate himself immediately to the most
important thing: to play.
FEATURES
Overdrive/ Distortion
From light run h to the powerful distortion
Chorus
Warm, intense and transparent. The heart of the ir uit
hip is based on the 3007 and 3101.
Dela
Crystal- lear sound, equipped with a hip " ompander"
and two 3205 hips to get up to a delay of 600ms!
You an reate, edit, store and re all up to 8 sounds
(pat hes) marked by the lighting of a 4-bi-LED (light or red
or green) with high luminosity.

4
OPERATION
1.In order to sele t the desired setting (s roll up)
2.In order to sele t the desired setting (s roll down)
3.In order to in rease the value of adjustment
4.For de rease the value of adjustment
5.For store the settings that you are viewing in the pat h
indi ated by the LED (requires two presses of a distan e of
not more than 1 se ond) and you re eive the message
"Storing ".
6-7.For sele t the desired pat h.
For this fun tion, there are two modes. When you turn on
the Multi mode that is a tivated first
allows the hoi e of pat h sequentially, with the "7" and it
goes with the "6" you go ba k one pat h at a time.
If you press both the buttons "6" and "7" mode is entered
a "reservation" with whi h you an book any of the 8
pat hes with "7" button (the LED flashes) and
subsequently onfirmed in the button "6".

5
CONNECTIONS
INPUT 1/4" mono ja k onne tor for signal input.
OUTPUT 1/4" mono ja k onne tor for signal output.
DC 9V Input Power. Requires 9V DC 300mA

6
TECHNICAL SPECIFICATION
INPUT
Impedan e 470K Ohm
Max Input level 2.2dBu
OUTPUT
Impedan e 50 Ohm
Max Output Level 3dBu
POWER
Voltage 9V DC
Conne tor DC Ja k Ø 6,3mm
Polarity Center is negative
Power Consumption 150mA
DIMENSIONS
Ex luding buttons 7.5” x 5” x 1.4” (190 x 130 x 35mm)
WEIGHT
3.3 lb. (1,5 Kg)