MECA EVO1 SQ User manual
EVO1 SQ
www.mecasimhardware.com
02 03
Introduction Table of contents
Contents of packaging
Shiter assembly
04
05
Dear customer, thank you for purchasing our MECA EVO1 SQ.
This EVO1 SQ sequential shiter was developed as part of our MECA
EVO1 series to accompany our newest pedal set. Before you install
or use the product, please read the manual which will provide the
basic information required for the first installation and the possible
configurations of our handbrake.
For any further information, please visit the "Support" section on our
website.
MECA EVO1 SQ Setup Guide | Introduction MECA EVO1 SQ Setup Guide | Table of contents
04 05
Contents of packaging
Handbrake
1x MECA EVO1 SQ shiter
4x M6x25 screw
8x Steel washer
4x Plastic washer
1x Special wrench for adjusting the spring
preload
1x Electronic box
Shifter as s e m b ly
MECA EVO1 SQ Setup Guide | Contents of packaging MECA EVO 1 SQ Setup Guide | Shiter assembly
1x Steel washer
1x M6 nut
1x Steel washer
1x Plastic washer
1x M6x25
Mounting to the rig
06 07
MECA EVO 1 SQ Setup Guide | Shiter assembly MECA EVO 1 SQ Setup Guide | Shiter assembly
Adjusting the spring settings and shifter handle replacement
Springs can be adjusted using special key included in package.
If you wish to change your shiter handle, you can do so. The handle is mounted on 30mm long M10 thread.
Adjusting the shift click feeling
You can adjust shiter click toughnes using the flat screw driver and 19mm wrench.
Don't tighten the sprung
ball screw fully, it will block
the mechanism
Use flat screwdriver
30,00
M10
Included in package Use 19mm wrench
www.mecasimhardware.com
CO NTAC T
Email: support@mecasimhardware.com
Website: www.mecasimhardware.com
Table of contents
