Media Crayon User manual

Assemble tables only as described in this
guide. All fasteners must be tightened
securely and checked regularly. Failure to
do so could cause instability and injury.
!
CAUTION
(800-001682-000)
5/16-18 X 50mm
BLACK
CONNECTOR
BOLT W/
SHOULDER
(800-000133-000)
#12 X 1 PH
SCREW
(800-000556-000)
1/4-20 X 90mm
BLACK CONNECTOR
BOLT WO/SHOULDER
(800-000068-000)
#8 X 5/8” PH
SCREW
(800-000001-000)
1/4-20
BLACK CONNECTOR
NUT
(800-000012-000)
#8 X 1-1/2” PH
SCREW
(800-000052-000)
7/8” DIA.
FLAT WASHER
(800-000054-000)
1X1X2
L-BRKT
(800-003290-000)
3/8-16 X 1-1/4”
HED FLAT HEAD
SCREW
(only with tables that include
disc base)
Hardware included:
Crayon
Tools Required:
• Phillips Head Screwdriver
• Allen Wrench 5/32” & 3/16”
Tables
instructions-crayon-220803

Assemble tables only as described in this
guide. All fasteners must be tightened
securely and checked regularly. Failure to
do so could cause instability and injury.
!
CAUTION
Unit may be supplied with either column or column with disc base, depending on size.
Reference assembly drawing included with shipment.

Assemble tables only as described in this
guide. All fasteners must be tightened
securely and checked regularly. Failure to
do so could cause instability and injury.
!
CAUTION
Step 1:
Attach Front leg to bottom of table using #12 x 1” PH screws (800-000133-000), 3/8”-16 x 1-1/4”
hex drive flat head screw (800-003290-000) to attach disc base if disc base is included.
Step 2:
Flip table over and place on top of box assembly with the box assembly 1’ or so back from back
edge of table to allow for fastening of tv support posts. Fasten tv support posts with 5/16-18 x
50mm connector bolts (800-001682-000) and 7/8” washers (800-000052-000).

Assemble tables only as described in this
guide. All fasteners must be tightened
securely and checked regularly. Failure to
do so could cause instability and injury.
!
CAUTION
Step 3:
Attach box assembly 1⁄4” from back edge of table with #8 X 1-1/2”
FH screws (800-000012-000).
Step 4:
Attach monitor panel with 1⁄4-20 connector nuts (800-000001-000)
and 90mm connector bolts (800-000556-000).
Step 5:
Assemble aprons on the underside using L-brackets (800-000054-000) and #8 x 5/8” PH screws
(800-000068-000).
Step 6:
Place cable grips on the underside where needed using #8 x 5/8” PH screws (800-000068-000).

Assemble tables only as described in this
guide. All fasteners must be tightened
securely and checked regularly. Failure to
do so could cause instability and injury.
!
CAUTION
* TV Monitor and bracket not included.