KI Ruckus Desk User manual

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Operating Instructions
Ruckus™Desk
Set Screw & Pneumatic Height-Adjustable
August 2019
Tools Required
• 1/8” Allen Wrench
Set Screw Height-Adjustable Desk
1. Carefully turn the desktop upside
down on a soft, protective surface.
2. Locate the two height-adjust screws
in the support column. Using a
1/8” Allen wrench, loosen the screws
until they both are slightly above
flush with the support column. This
must be done to prevent the screws
from scratching the base while
adjusting the height (Figure 1 &
Detail A).
3. Move the base up or down to desired
height (1” increments) and align set
screws to adjustment holes in the
base. Using a 1/8” Allen wrench, twist
one set screw into the adjustment
hole in the base loosely, finger-tight
to just below flush with the outer
column. DO NOT tighten the set
screw (Figure 2 & Detail B).
4. Next, using a 1/8” Allen wrench,
tighten the second set screw into the
base adjustment hole, to just below
flush with the column. The first set
screw will draw tighter from this
process. Ensure that both set screws
maintain equal depths (Figure 2 &
Detail B).
5. Carefully turn the desk to the upright
position.
Note: Adjustable leveling glides
are supplied on Ruckus desking.
Glides may be turned clock-wise to
account for un-level floor conditions.
Each adjustable swivel glide has a
threaded stem which must turn to
adjust the glide.
height adjust
set screws
Figure 1
support
column
base
Figure 2
base
support
column
height adjust
set screws
Detail
A
1/”Allen head
height-adjust
set screw
8
support
column
1/”Allen head
height-adjust
set screw
8
Detail B
support
column
1/”Allen head
height-adjust
set screw
8
1/”Allen head
height-adjust
set screw
8

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel [phone] • www.ki.com
© 2019 Krueger International, Inc. All Rights Reserved • Code KI-OI-000003R1/KI/PDF/0819
Ruckus™ Desk - Pneumatic Height-Adjustable Desk
Assembly Instructions
Pneumatic Height-Adjustable
Desk
1. To raise the height of the desk, lift
the height adjustment lever located
at the back non-user side of the
worksurface (Figure 1 & Detail A).
2. To lower the height of the desk, lift
the height adjustment lever while
applying downward force on the
worksurface, directly above the
support column (Figure 2 &
Detail A).
Note: Adjustable leveling glides
are supplied on Ruckus desking.
Glides may be turned clock-wise to
account for un-level floor conditions.
Each adjustable swivel glide has a
threaded stem which must turn to
adjust the glide.
Figure 1
height
adjustment
lever
support
column
height
adjustment
lever
Detail A - Height Adjustment Lever
height
adjustment
lever
support
column
worksurface