Meelectronics SPORT-FI User manual

USER MANUAL
SPORTS EARPHONES
WITH MEMORY WIRE
IMPORTANT
Please read this manual in its entirety
to ensure best fit and sound.
visit www.meelec.com/fit for fit tutorial
videos and additional info.

CONFIGURING FOR YOUR EARS:
EARTIPS
Multiple sets of eartips are included to ensure you
get the best fit with your Sport-Fi earphones.
We recommend trying all of the included eartips.
If you experience tinny sound or a lack of bass,
try different eartips.
The correct eartip for your ear will:
Allow the earphone to fit flush in the ear
Seal with your ear canal and reduce outside
noise when inserted
Provide good bass response
1
3 4
2
Install eartips as shown. Make sure eartips are
installed securely before use.
•
•
•

CONFIGURING FOR YOUR EARS:
memory wire
Sport-Fi earphones feature an over-the-ear fit with
a flexible “memory wire” section located near the
earpieces. Using the memory wire correctly will
ensure the most comfortable and secure fit.
1.2
1.1
Straighten the memory wire and put
each earpiece in the corresponding ear
Identify the right and left earpieces as
indicated by the “L” and “R” markings.
They are not interchangeable.
Basic Remote Operation
for iPhone ® and most Android ™ phones:

Holding the earpiece in place, bend the
memory wire around your ear to achieve
a conforming fit
Adjust each earpiece until it fits flush in
the ear and the eartip seals in the ear
2.1
2.2

While pulling the cable gently with one hand,
squeeze the memory wire behind your ear with
the other hand until the fit is tight and secure
3
PULL
OVER
EAR
PULL
OVER
EAR

Use the shirt clip to control
cable movement during activities
Tighten the sliding cable cinch to fix the
earphones in place for the most secure fit
4.2
4.1
SLIDE THE
CABLE CINCH UP
CABLE CINCH
SHIRT CLIP
HOLDS CABLE
IN PLACE

When worn correctly, the earphone sits flush in
the ear and the cable is secure behind the ear
5

SUBSEQUENT USE
After first use, the memory wire will retain its
approximate shape for easier future installation.
To put the earphones on, pull the
earpieces over from behind the ear,
placing the memory wire over the ear
1
PULL
OVER
EAR
PULL
OVER
EAR

Note: If you must remove and reinsert the
earphones while working out, avoid getting sweat
in the nozzle as this may lead to a temporary
reduction/loss of sound.
Insert the earpieces into your ears
and adjust until a seal is achieved
Squeeze the memory wire behind your ear
until the fit is tight and secure. Use the cable
cinch and shirt clip to control cable movement.
2.2
2.1

MICROPHONE & REMOTE USE
(M3P, M6P and S6P only)
Sport-Fi headsets include an inline remote and
microphone.
Basic Remote Operation
for iPhone
® and most Android ™ phones:
Phone Mode
Incoming call
Phone call in progress
Button Press
Single press
Single press
Action
Answer phone call
End call
volume control
(M6P and S6P only)
For maximum volume, move
the slider to the + position
maximum volume setting
universal volume control
microphone
remote button
+
Additional remote functions are available with Apple
and Android devices. Visit meelec.com/phone
for complete compatibility and functionality.

care and cleaning
WARNING
Using headphones at high to moderate volumes
for extended periods of time will result in permanent
hearing damage. Do not use while driving a car,
cycling, operating machinery, or performing other
activities that require hearing surrounding sounds.
It is advised to turn the volume on your device all
the way down before connecting your headphones,
then gradually increase the volume until you reach
a comfortable listening level.
TROUBLESHOOTING
Visit meelec.com/troubleshooting for solutions to
common issues.
WARRANTY
MEElectronics earphones purchased from authorized
retailers are covered by a 1-year manufacturer
warranty. Visit meelec.com/warranty for warranty
information.
MEElectronics and its logo are registered
trademarks of S2E, Inc. All rights reserved.
iPhone® is a registered trademark of Apple Inc.
Android™ is a registered trademark of Google Inc.
Do not remove from ears or unplug by pulling on
the cable. Always grasp the plastic part of
the plug or earpieces
If necessary, clean the earphones with a small
amount of hydrogen peroxide on a cotton swab.
Swab only the outside of the earphone. Eartips
can be removed and rinsed under running water
or in hydrogen peroxide. Allow earphones and
eartips to dry completely before resuming use.
•
•

www.meelec.com