MEEPO V3S User manual

MANUAL
@MEEPOBOARD | WWW.MEEPOBOARD.COM V3S

COMMUTE IN STYLE

READ THE MANUAL CAREFULLY
BEFORE YOU RIDE
This can occur due to radio interference, a malfunctioning
battery, downhill overcharging of the battery, or other
factors. Only ride your Meepo board at speeds and on hills
where you don’t have to depend on brakes and acceleration.
YOUR BOARD MAY LOSE POWER AND BRAKES
Always be aware of your surroundings when riding in the pres-
ence of vehicles. Ride cautiously and assume the vehicles
can’t see you. Remember that your board may lose power and
brakes at any moment. Whenever you are riding, please be
aware of the laws that govern the use of your board on public
roads, bike paths, sidewalks, or other places that you may ride.
CARS AND OTHER VEHICLES CAN INJURE YOU
Additional safety gear, like gloves, pads, and long sleeves, are
highly recommended.
ALWAYS WEAR A HELMET
Crashes in these conditions may cause serious injury. Be extra
careful when pushing the limits of the board, even if you’ re an
experienced rider.
HILLS AND HIGH SPEEDS CAN BE VERY DANGEROUS
Regenerative braking may overcharge the battery. To prevent
this from happening, the remote will warn you by beeping, and
disable your braking power. Safely come to a stop before this
happens, and ride on flat surfaces or uphill to drain the battery
before attempting to ride downhill again.
BRAKING DOWNHILL WITH A FULL BATTERY WILL
CAUSE THE BOARD TO SHUT DOWN
Which means the board can accelerate aggressively ,causing
you to fall off. Try to start by moving slowly in these modes to
ensure safety.
WARNING! IN EXPERT AND PRO MODE THE THROTTLE
IS EXTREMELY SENSITIVE

2
M4s Remote
MEEPO V3S 1
Press the power button once
or push-start the board.
On/Off Switch
Board Charge Port
USB Charging Port
Battery Display Wake Up
Battery Display
Skateboard Deck
Battery Case
ESC
Hub Motors
Front Wheels
Front Truck
Rear Truck

3
Pairing the Remote And Board
7S
The screen on the remote will show “pairing”.
When the power button blinks rapidly and the remote displays all the
specs, the board and remote have been paired.
If you have an old remote, make sure it is turned off.
Hold the power button on the board for 7 seconds, until it blinks slowly.
Press the “power” and “function” buttons on the remote at the same time.
4
Check the Board Battery Life on the Remote
5
Charge the Remote
6
Charge the Board
Charging Port
Charging Port
The remote takes several hours to charge.
If the board and remote are charging at
the same time, the remote should finish
charging before the board.
Warning: Never leave your board unattended while charging.
Skateboard
Battery Remaining
(When the remote's power on)
2S

7
Riding Basics
Regular Goofy
Your Meepo board has a lot of power. Follow these tips to ensure a safe
riding experience:
ARE YOU A “REGULAR” OR “GOOFY” FOOTED RIDER?
Typically, if you kick a ball with your right foot, you are a regular footed
rider. However, this is not always the case! Try both stances to see what
feels best. If you don’ t know which to choose, one advantage of riding
goofy footed is that you have a better view of the traffic.
8
Change Ride Mode
The board is set in beginner mode by default. Before switching modes,
make sure you have mastered the beginner mode.
1: Limited acceleration.(7mph)
2: Moderate acceleration.(15mph)
3: High acceleration.(25mph)
4: Max acceleration.(29mph)
WARNING: The throttle wheel is much more sensitive in HI and PRO
modes. To avoid getting thrown off from the board, follow these tips:
• Start by moving forward slowly.
• Move the throttle wheel in small increments.
• Keep a wide stance on the board.
• Keep a low center of gravity.
• Lean forward when accelerating.
• Lean backward when braking.
It usually takes the remote several hours to get fully charged. If the board
and remote are charging at the same time, the remote will be charged
first.
CYCLE THROUGH SPEED /BRAKE MODES:
STANCE
Move the throttle wheel in small increments.
Keep a wide stance on the board.
Keep a low center of gravity.
Lean forward when accelerating.
Lean backward when braking.
Press the function-button once to
change speed modes.
While holding the throttle down press the
function-button to change brake modes.
L
R
R
L

9
Get Ready to Ride
Downhill
Grates/Drains
Poor Visibility
Uphill
Tracks
Obstacles
Water
Larger Rocks
Night Riding
Gravel
Cracks
Traffic
Always wear a helmet.
Find a flat, paved area with no obstacles for your first ride.
Read and understand the entire manual.
For more details, check out our website: www.meepoboard.com.
Other protective equipment is highly recommended.
AVOID THESE OBJECTS AS THEY CAN MAKE YOU LOSE
CONTROL OR CRASH:
To insert a new battery pack, align the grooves on both ends of the
connector (board & battery pack).
Insert, connect, and adjust the two ends of the connector together. Make
sure to tighten the connector to make a good seal.
Ensure the connector lays flat within the accessory wire and the groove
of the board.
Replace and tighten the bolts with the hex wrench, and put the grip tape
back on.
10
Replace the Battery Pack
11
More Information Online
This manual is a quick start guide intended for someone with little experience
in riding electric skateboards. If you want to learn more on how to start riding,
superior riding skills, and solutions for riding problems, please visit our website:
www.meepoboard.com or send us an email at [email protected].
GETTING STARTED
How to stand on the board
How to turn
How to find a good spot to practice
ADVANCED TECHNIQUES
How to footbrake
How to ride uphill and downhill safely
What to look for when riding through traffic
MAINTENANCE
Pre-ride inspection
Routine maintenance

PRODUCT SPECIFICATIONS
BATTERY SAFETY AND HANDLING INFORMATION
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to instructions.
Failure to follow these safety instructions could result in fire,
electric shock, or other injury or damage to the Meepo Hurricane
skateboard and Meepo M5S remote or other property.
WARNING!
Whenever riding a electric skateboard, make safety your top priority.
Loss of control, collisions, and falls may cause serious injury to you.
Please ride responsibly and respect those around you. How you ride will
determine how people view this new mode of transportation.
Do not attempt to disassemble the product without
consulting Meepo. Should your unit need service, contact our
Customer Service by sending an email to [email protected].
If this equipment does radiate harmful interference to radio or television
reception, fix the problem by trying one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a different circuit from
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Prolonged exposure to sunlight may discolor or weaken the plastic cases, as
they are not UV Rated.
Meepo V 3S Skateboard: Rated Input: DC 42V 2A
M4S Remote:Rated Input: 5Vdc, 500-1000mA Operating
Temperature: 0-40°C, 10-90% RH
The board specifications were obtained under perfect conditions. Each
customer will have different conditions that will make the eboard perfor-
mance fluctuate from the data we present.
WARNING: AVOID WATER!
WARNING: PINCH POINTS
WARNING: RISK OF ELECTRIC SHOCK!
WARNING:
WARNING:
Always wear a helmet when riding. Never ride in the rain, or on wet,
slippery or uneven surfaces with steep hills, traffic, cracks, train tracks,
gravel, rocks or any obstacles that could cause a loss of traction. Avoid
night riding in areas with poor visibility or narrow spaces.
WARNING:
Riding in wet conditions or through puddles can
damage the board’s electronics and cause the board
to lose power or stop suddenly. Damage to the board
due to water exposure is not covered under the
warranty.
Keep fingers, hair, and clothing away from motors,
wheels, and all moving parts.
Do not open or tamper the case or battery with
cleaning products, this will void the board’s warranty.
This equipment has been tested and complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and
radiates radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
CAUTION
CAUTION
IMPORTANT SAFETY AND HANDLING INFORMATION

Changes or modifications to the skateboard unapproved by Meepo may void
the user’s warranty.
This product is intended to be equipped only with Meepo Hurricane batteries.
Do not drop or throw the battery.
Keep the battery away from kids.
Never expose this product or the battery to any liquids.
Never throw the battery into a fire, it could cause the battery to explode.
Never bring the connector terminals in contact with another metal object, it
will short-circuit the battery. Short-circuit could cause personal injury, fires or
damage to the battery.
Your device contains an internal rechargeable lithium-ion battery which may
present a risk of fire or chemical burn if mistreated. Do not charge or use the
unit in a car or places where the temperature surpasses 40°C.
The charger supplied with the electric skateboard
should be regularly examined for damage to the
cord, plug, enclosure, and other parts. In the event
of such damage, the skateboard must not be
charged until the charger has been repaired or
replaced.
Unplug the charger and disconnect it from the skateboard when not in
use.
CAUTION
Power cord is used as a disconnection device. To fully de-energize
equipment for service, disconnect the charger power cord.
WARNING
BATTERY CHARGING INFORMATION
The charger is designed for indoor use only. Do not expose the charger to
liquid, moisture or extreme humidity. Do not charge the Meepo skateboard or
Meepo remote outdoors or in the rain.
Stop charging the skateboard and/or remote if charging isn’t completed
within the specified time.
Stop charging the skateboard and/or remote if the batteries become abnor-
mally hot, show signs of odor, discoloration, deformation, or if abnormal
conditions are detected during use, charging, or storage.
Do not charge the skateboard and/or remote if the battery enclosure
becomes cracked, swollen, or shows any other signs of damage. Discontinue
use immediately and promptly dispose of unit.
Your device should not be placed in municipal waste. Please check
local regulations for proper disposal of electronic products.
If this unit shows any type of damage, such as bulging, swelling, or malforma-
tion, discontinue use and immediately contact Customer Service by sending
a mail to [email protected].
Dispose of used batteries in accordance with the prevailing community regu-
lations that apply to the disposal of batteries.
Never dispose of used batteries with other ordinary solid wastes.
Batteries contain toxic substances.
PRODUCT AND BATTERY DISPOSAL INFORMATION:

This board is covered by a 180 day manufacturer’s warranty that covers
defects in workmanship and material. This does not cover damage caused by
abuse, misuse, negligence, accidents, or riding in water.
If the product has a manufacturing defect within 180 days of ship date,
contact [email protected]
Each board was tested for at least 20 miles before shipping it out. So it is
normal to spot some dirt or dust on the board, and certain mileage on the
remote.
Please keep your shipping box. The warranty does not include damage from
return shipping with lack of package material.
For any concerns regarding your board, please contact Meepo’s customer
service by going to www.meepoboard.com or by sending an email to:
[email protected].
WARRANTY AND MAINTENANCE
LIMITED WARRANTY
Store your board in a dry area. If you are not going to ride your board for a
long time, fully charge your board at least once a month to unrecoverable
prevent irreversible battery damage.
MAINTENANCE FOR BOARD WHEN NOT BEING USED
FOR ALL RETURN AND WARRANTY SHIPPING:
If you accidentally ride in the rain or on wet surfaces, wipe off all the water on
the surface of your board, especially the charging port. Do not charge your
board until it is completely dry. Then, run the motors so that the wheels are
spinning for 10 minutes in order to dry the inside of the motors and avoid rust.
MAINTENANCE AFTER WET SURFACES
MEEPO ELECTRIC
SKATEBOARD COMPANY
Online Store Customer Service
Room 2015, Trend Centre, 29-31 Cheung Lee Street, Chai Wan, Hong Kong
Company address
Online Store
www.meepoboard.com
Customer Service Email Address
[email protected]