MeErgo ErgoChair User manual

ErgoChair
Assembly Instructions
WWW.MEERGO.COM.AU

WARNING
Please carefully read and follow this instruction. Failure to follow this instruction may
result in serious injury. Any damage or faults caused by assembling or using with not
following the instruction may not be covered by warranty and return policy.
1. This product is designed for seating ONLY. Do not stand on this product. Do not use
it as a step ladder.
2. Do not use this product unless all the bolts and parts are firmly tightened.
3. If any parts are missing, damaged or worn, stop using this product. Prepare the
product with manufacturer’s supplied parts.
4. Do not sit on the armrest of this product.
5. This product is designed for sitting one person at a time.
6. Children under the age of 10, please use under adult supervision.
7. Avoid sharp objects (buckles, jeweler, keys, pet claws, etc.) near the product.
8. Protect from sunlight and direct heating sources.

List of Parts and Bolt packs

Flip over the base and insert the gas cylinder into the middle hole on
the base.
Put the base F upside down the floor and insert all the casters D into
the base.
Flip over the seat pad and align the holes on the armrest and the
bottom of the seat, insert bolts K and washers N, use the Tool M to
tighten the bolts.
Before assembling the mechanism, put the handle up and hold (see
picture blow), use another hand to push the mechanism forward. This
step is to ensure the mechanism is in the right position in order to let
it being easily put together with the seat in the next step.

Place the mechanism on the back of the seat pad, make sure to put
the mechanism on the right direction as shown in the picture below.
Align the pre-built holes on the seat and mechanism, insert the bolts
L, spring locks P and washers O with the right order shown below in
the pre-drilled holes, the tighten them by Tool M.
Align three pre-dilled holes at the end of mechanism and the end of
the backrest, insert bolts I, spring locks P and washers O into the holes,
then tighten the bolts by Tool M.
Lift the assembled chair and carefully align the hole in the middle of
the mechanism to let it fit into the gas cylinder and put it down until it
perfectly fitted.
Assemble the other two bolts as same as step 5.