MEGABLEU Ghost Hunt User manual

2. SPEED OF THE GAME
The speed at which the ghosts appear gets determined by the buttons
located at the base of Billy Bones:
I = (easy) II = (Average) III = (Difficult).
3. SHOOTING GHOSTS
Billy Bones turns his head to project ghosts on the wall or ceiling one by
one.
The player has to aim his gun at the ghost and press the fire trigger to
hit a ghost before it disappears.
If a ghost has been hit, the gun will produce a small scream and will
register 1 point.
Fire Trigger
Reload button
LCD-Display
which shows
how many ghosts
you hit
4. RELOADING THE GUN
The gun has a total of 6 shots. After 6 shots you need to press the
reload button at the top in order to load another 6 shots and continue
the game (reload button).
5. END OF A SHOOTING SESSION
The skull will continue to project ghost images for around one and a
half minutes. Players need to shoot as many ghosts as they can. After
one and a half minutes, both gun and skull will stop. The number of
ghosts shot by the player is shown on the LCD display on the gun. You
can put the counter back to zero by pressing the trigger.
6. PLAYING A NEW GAME
To start a new game you have to push one of the buttons located on
the pillar of Billy Bones: I, II or III.
Synchronise again as described in point 1 «synchronisation».
7. ENDING THE GAME
If you decide to end the game, put the ON-OFF switch to OFF.
You do not need to turn off the gun. It will turn itself off after 1 minute.
2 PLAYERS OR MORE
Each player plays the game in his turn.
At the beginning of each game the player has to synchronise the gun
and the projector before a new game can start.
The one who shoots the most ghosts is the winner.
Remark: to determine the winner it is also possible to:
- set a certain score everyone has to reach (ex. 100 points).
- play different shooting sessions (ex. 3) and aim for the highest score.
PLAYING INSTRUCTIONS
1. Synchronisation of projector and gun
- Switch the ON-OFF switch located at the bottom of the projector
to “ON”.
- Activate the gun by pressing the fire trigger. LCD screen lights up
(a firm red light burns and the counter says ‘00’).
Remark: the gun turns itself off after 60 seconds. To enable the gun you
have to press the fire trigger (there is no ON-OFF switch for the gun).
- Select difficulty level of playing by
pressing the buttons on the projector: I, II or III.
- The right eye of Billy Bones will flash and will project an image of
a white ghost on the wall or ceiling of the room. Aim the gun to the
ghost (or to the right-hand eye of Billy Bones) and press the fire
trigger.
- The gun now synchronises itself with the projector and a “beep
beep” sound will be heard.
- The head of Billy Bones will start to turn and the gun will make
different sound effects. From this point the game can start.

© 2012 MEGABLEU
3 x AAA
4 x AA
VERY IMPORTANT
- For each game the electronic projector must synchronise with the gun to be able
to start playing the game. Please read carefully paragraph 1 “synchronisation” under
chapter “PLAYING INSTRUCTIONS”.
- The white line displayed on the front side of the box, between the gun and Billy
Bones, is just an illustration. The infrared line of the gun is not visible.
OBJECT OF THE GAME
To hit as many ghost as possible within a limited time frame.
SET UP
Attach the right-hand and left-hand foot of Billy Bones to the pillar as shown in
the diagram below (to be assembled by an adult).
Maximum shooting distance of the gun is 2.5 metres.
Make sure that the room you play in is smaller than 5x5 metres.
Place the projector on a table in the middle of the room.
Put out the lights (or shut the curtains) until the room gets sufficiently dark.
Do not play in a room which has a glass wall.
maximum 2.5 m
REPLACING BATTERIES
1. The gun
- Open the batteries area by using a screw driver.
- Install 3 AAA batteries taking into account the “+”
and “-“ battery terminal as described in the battery area.
- Screw the battery cover again to the gun.
2. Billy Bones projector
- Open the batteries area by using a screw driver.
- Install 4 AA batteries taking into account the “+”
and “-“ battery terminal as described in the battery area.
- Screw the battery cover again to the gun.
SAFETY REGULATIONS
Caution
• Replacing batteries should always be done by an adult or under the supervision of an adult.
• Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly matching the + and –
polarity markings.
• Rechargeable batteries: do not mix these with any other type of batteries. Always remove from the product before recharging.
Recharging should be done under adult supervision. Do not recharge other battery types.
• Do not short-circuit the supply terminals.
• Do not mix used batteries with new ones, standard (saline) with alkaline and rechargeable batteries with standard or alkaline
batteries.
• Do not try to supply the product with power through use of mains power or another independent power supply system.
• Remove batteries if product is not to be played with for a long time.
• Remove exhausted or dead batteries from the product.
• Bring your used batteries to an authorized waste disposal centre.
• Keep batteries away from fire. Danger of explosion.
• Should this product cause, or be affected by local electrical interference, move it away from other electrical equipment. Reset if
necessary (switching off and back on again or removing and re-inserting batteries).
• Please retain this information for future use.
Main Problems:
Warning ! Choking hazard. Not suitable for children under 36 months due to small parts.
Distributed in the UK by:
Goldfish & Bison
20 Market Place, Brentford
Middlesex - TW8 8EQ
[email protected]om
Manufactured in China by MEGABLEU
Route de Bresolettes 61190 Randonnai - France
Tél.: [phone]
www.megableu.com
RULES OF THE GAME
1 or more players
Content:
1 electronic projector* (Billy Bones)*, 1 electronic gun**, 1 manual
*Works on 4 AA batteries (not included), **Works on 3 AAA batteries (not included)
Billy Bones does not turn his
head or his head turns too
slowly
The power switch is set to the
OFF position and/or weak or
dead batteries
The power switch should be
set to the ON position. Insert
new batteries or recharge
batteries in case of
rechargeable batteries.
Insert new batteries or recharge
batteries in case of rechargeable
batteries. Darken the room or play in
a darker room.
Insert new batteries or
recharge batteries in case of
rechargeable batteries.
Move the projector closer to the
wall. Insert new batteries or
recharge batteries in case of
rechargeable batteries.
Weak or dead batteries and/or the room
is not dark enough or there is a glass wall
in the room.
Weak or dead batteries The distance between the
projector and the wall / ceiling
exceeds 2.5 metres. Weak or
dead batteries.
The ghost image that is projected
on the wall is not clear.
The sound or light from the
LCD screen of the gun is too
weak.
The shot of the gun does not
reach the image of the
ghost.
PROBLEM
POSSIBLE CAUSE
SOLUTION