MegaChef MCG-106 User manual

Model No. MCG-106INSTRUCTION MANUAL
The
Reversible Tabletop
Grill by

WARNING
Please use and keep the grill and its
supply cord out of the reach of children.

IMPORTANT SAFEGUARDS
1. READ ALL INSTRUCTIONS
2. Do not touch hot surfaces; use handles or knobs.
3. To protect against re, electric shock, and injury
DO NOT IMMERSE CORD OR PLUG in water or other liquids.
4. Close supervision is necessary when any appliance is used by
or near children.
5. Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking o parts, and before
cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug, or
after the appliance has malfunctioned or has been damaged in
any manner.
7. Please do not use any accessories which did not come with the
unit.
8. This grill is meant to be used indoor only.
9. Do not let power cord hang over the edge of the table or
counter, or touch hot surfaces.
10. Do not place on or near hot gas or electric burner, or in a
heated oven.
11. Unplug the unit when it is not in use.
12. Do not use appliance for other than intended use.
13. Extreme caution must be exercised when moving an
appliance containing hot oil or other hot liquids which have
been used cooking
FOR HOUSEHOLD USE ONLY

A
B
C
D
E
F
Glass Lid
Glass Lid Handle
Nonstick Surface
Handle
Base
G Temperature
Controller
COMPONENTS
Drip Tray

Figure 1 Figure 2
Figure 3 Figure 4
INSTALLATION GUIDE
1. Remove all packing material and any stickers.
2. Before use, wash the Nonstick Surface (C )and the drip tray (E)
in hot water and a mild detergent. Dry them thoroughly.
3. Fit the drip tray (E) inside the base (F),inserting it rst under
the lock tab in the back of the base (Fig.1) before lowering it into
its place. (TIPS : To make cleaning easier,cover the drip tray (E) with foil to collect any
excess cooking .)
4. Place the Nonstick Surface (C) over the drip tray (E)(Fig.2),
making sure that the handles (D) slid perfectly into the slot
located on each side of the base
5. Place the food for cooking on the plate (C) and insert the lid(A)
vertically so that the side pins slide into the slots located on
each side on the back of the base(F)(Fig.3)

6. Lower the lid (A),gripping the handle and turning it gently Up
forwards(Fig.4)
7. Insert the temperature controller (G) into the inlet(I) located
on the side of the nonstick surface plate (C)(Fig.5) and plug the
power cord into a socket. Refer to below photo :
INSTALLATION CONT.
Figure 5
I Inlet
G
Temperature
Controller
C
Nonstick Surface
8. Set the dial on the Temperature controller (G) to the required
heat setting .
Please refer to the“Operation”- Set the dial on the Temperature
controller (H) to the required heat setting.

OPERATION
1. Turn On by turning the dial on the Temperature Controller (G)
from the “OFF” position
2. Continue turning the knob to the desire temperature based on
the food being prepared.
3. Please refer to the table below with dierent settings:
Function Settings
Settings Function
Warm - 250F Low Heat - to keep food warm
Medium Heat - Cooking foods thoroughly
High Heat - For quick cooking and sealing the juices
Super Heat - To brown foods quickly
250F- 350F
350F - 400F
450F
4. The light on the Temperature controller (G) will turn red to
indicate that the unit is in the“On” position and warming up to
the desired temperature.
5. The indicator light on the Temperature controller (G) will
switch o once the desired temp has been reached, and the
grill’s ready for use
6. The indicator light on the temperature controller(G)shows that
the grill is heating up and it will stay lit until the grill reaches the
set desired temperature chosen by the operator; after this, it will
switch on and o in cycles during the cooking process to
guarantee that the selected temperature is maintained.
7. The pre-heating time depends on the chosen heat setting.
The higher the selected temperature,the longer the pre-heating
time will be.
8. When cooking is complete, remove the temperature controller
(G) carefully which might be hot, and lift the lid(A) using the
handle.
This product is for household use only.

HOW TO USE
1. Make sure to remove all packing materials and any stickers on
or around the Tabletop Grill before usage.
2. Before plugging in the unit, wipe both side of the non stick
surface plates(C) with a damp cloth or sponge to remove any
dust. Wipe dry with a soft cloth or paper towels.
3. Place the Tabletop Grill on a at surface leaving enough space
between the back of the unit and the wall to allow heat to ow
without damage to cabinets and walls.
4. Before plugging in the Temperature controller to the machine,
please make sure the knob is in the “O” position.
5. Make sure the Temperature controller(G) knob is visible, where
the user can control the cooking temperature.
6. Adjust the dial to lower temperature for preheat, then adjust
the controller to the appropriate heat setting for your desired
cooking option
7. Once the desired food is cooked make sure to always use a
spatula, wooden heat resistant silicone cooking utensils . Do not
use any metal utensils, they can damage the nonstick coating.
8. Important: HOT Steam may be released between the
cooking plates. Caution should be taken to prevent hands or
face from coming into contact with the steam.
9. After use, turn the temperature knob to “OFF”position
unplug unit from the electrical outlet and allow it to cool down
until it reaches room temperature before cleaning.
10. Carefully take out the detachable grease tray and discard the
remaining cold oil.

HOW TO USE GLASS LID
1. The glass lid has a latch with a locking mechanism.
2. Once the glass lid is lowered, the latch will automatically lock
the lid.
closed position
3. To open the Glass lid, using a nger, lift the latch under the
Glass lid to unlock and lift to an upward position. (Fig.6)
4. By lifting the glass lid all the way, the glass lid will stay in an
upward resting position.
Figure 6

CARE AND CLEANING
Always unplug the power cord from the electricity before
tting or removing single attachments or before cleaning
the appliance.
Never place the thermostat, plug or power cord in water or
other liquids; Only wipe these parts clean with a damp cloth.
1. Wipe lid, base, and cooking plates with a damp cloth and a
non-abrasive soap or dish washing detergent. Wipe with a clean,
soft, damp cloth and dry towel.
2. Storage: Store cleaned machine in a clean, dry place.
3. Never take out the detachable grease tray out to clean
when the oil still hot
4. Never store while it is still hot or still plugged in.
5. Never wrap cord tightly around the appliance. Do not put any
stress on cord where it enters unit, as this could cause it to fray
and break.
6. The lid, the non-stick plate and the drip tray can be washed in
warm soapy water. The shaped base can be wiped clean with a
damp cloth or washed using lukewarm water, a mild detergent
and a soft cloth,or in the top rack of the dishwasher.

FOR WARRANTY INFORMATION AND FEEDBACK,
PLEASE VISIT
WWW.MEGACHEF.COM