meitav-tec TED220-HC11-3S User manual

www.meitavtec.com | [email protected] File: TED220-HC11-3S_operatingmanual.doc
Page 1 / 2
OPERATING MANUAL TED220-HC11-3S
COMP/STBYON
OFF ON
I II III
COOL HEAT
1
2
5
3
64
TEMP
7
1. Green LED – ‘ON’ LED ON Unit ON
LED OFF Unit OFF
2. Red LED – ‘COMP/STBY’ LED ON Compressor active
LED Flashes 4 Minutes compressor delay
3. On/Off switch ON Turn the unit ON
OFF Turn the unit OFF
4. Temperature adjustment Knob Range: 10°C ÷ 30°C
5. Mode selector COOL Cooling mode
HEAT Heating mode
6. Fan speeds selector I Low speed
II Medium Speed
III High speed

www.meitavtec.com | [email protected] File: TED220-HC11-3S_operatingmanual.doc
Page 2 / 2
INSTALLATION INSTRUCTIONS TED220-HC11-3S
Disconnect power to the main
board before installing the unit.
The thermostat is designed for wall
mounting in the room to be controlled. It
should be located where the occupant
can easily read the LCD display and use
the controls.
If the built in temperature sensor is being
used to measure room temperature, the
unit should be placed where the
temperature is representative of the
general room conditions.
Cold or warm air draughts; radiant heat
and direct sunlight should be avoided.
•Gently pull out the temperature adjustment knob (A).
•Use a Phillips screwdriver to remove the screw located behind the knob (B).
•Gently separate the front panel (C) from the back panel (D).
•Line the back panel up against the wall or flat surface. Install three screws as required.
•Make electrical connections as shown in the wiring diagram.
•Reattach the cover to the back panel using the screw and push the temperature adjustment
knob back to its place.