Mercedes-Benz GLA Use and care manual

Replacement of panoramic roof
retaining cleats for mercedes
Gla-Cla-A-C-E
w176-w177-w205-c207-c117
(without dismantling, modifications,
special tools and reprogramming)

1- open the sunroof (position it halfway where it has the
most amplitude)
IMPORTANT
2- Make sure that there are no damaged parts left in the
slides (clean the rail and grease it)
3- The sunroof must be free, take care to remove the old
cleats (even if these are not damaged)

4- Position the new cleat perpendicular to the rail The 2
pins must not protrude into the groove so as not to
interfere with the descent of the Roof fixing

5- Press (lightly) the 2 upper sides of the cleat and rotate it (if the
2 locking pins bother you, remove them and reinsert them a few
mm once the cleat is positioned)

6- The 2 locking pins must be towards the front of the vehicle

7- Slide the cleat under the sunroof mounting Repeat the
operation for the other slider so that the sunroof mountings are
both resting on the cleats
8- Check that the 2 cleats are aligned in the axis of the sunroof
mounting
9- Exert slight pressure on the sunroof so that the fixings go down
to the bottom of the cleat. (if necessary use a flat screwdriver to
spread the cleat a little)

10-Once the bindings are in position in the cleats, lock them by
pushing the 2 pins (use a pin-type tool to push the pins into
position until they are flush with the face of the cleat)

11-Your sunroof is now operational Operate it several
times to ensure that the replacement cleats are fitted
correctly.
Follow the assembly instructions carefully, we cannot be
held responsible in the event of a problem due to
improper handling.
Thank you for your confidence