Merco Zala 150 User manual

Zala 150, 180
bench without a backrest
Instructions
ID: 63332, 63334
EAN: 8591792633320, 8591792633344

Package contents
Part number / description
1. wooden lath, 5 pieces, of which 2 with one rounded edge
2. Metal side panel, 2 pieces
3. Metal connecting rod, 2 pieces
4. Metal plate-reinforcement length 34 cm,1 piece
5. Self-tapping wood screw long, length 3 cm, 10pieces
6. Self-tapping wood screw short, length 2.4 cm, 5 pieces
7. Connecting screw with thread, length 3 cm, 4 pieces
8. Metal expansion anchor bolt, 4 pieces

Assembly instructions
1. Place the metal sides 2 on the floor next to each other about the length of the wooden
slats.
2. Place two connecting rods 3 in the inner part of one side and screw lightly with screw 7 -
do not tighten. Then attach to the other side and screw with screw 7, do not tighten.
3. Insert the wooden slats 1 into the upper part of the sides with the painted side up. Place
laths with rounded edges first and last.
4. Screw the slats to the sides with long self-tapping screws 5. Always point the hole in the
side to the center of the slats beforehand.
5. Tighten the screws 7 to the connecting rods 3.
6. Turn the assembled bench upside down and screw the metal reinforcement 4 to each
center of the seat with short self-tapping screws 6.
7. If you want to fix the bench to a solid surface, use the anchor bolts 8 and fasten them to
the cut-outs in the legs of the bench.
Importer to Czech Republic:
RADANSPORT s.r.o.
Za Otýlií 10 370 01 České Budějovice
email: [email protected]
phone: [phone]