3
– Slots and openings in the cabinet are provided for ventila-
tion.These ensure reliableoperationoftheproductandpro-
tectit fromoverheating.Theseopenings mustnotbe blocked
orcovered.(Theopenings should never be blocked by plac-
ingthe product on bed, sofa, rug,orsimilarsurface. It should
not be placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided and the
manufacturer’s instructions have been adhered to.)
Forproper ventilation,separatethe productfromother equip-
ment, which may prevent ventilation and keep a distance of
more than 11-7/8" (30 cm).
– Thisproductshouldbeoperatedonlywith the type of power
source indicated on the label. If you are not sure of the type
ofpower supply to your home, consult your product dealer
or local power company.
– This product is equipped with a three-wire plug. This plug
willfitonlyintoagroundedpower outlet. If you are unable to
insert the plug into the outlet, contact your electrician to
install the proper outlet. Do not defeat the safety purpose of
the grounded plug.
– Power-supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or
against them. Pay particular attention to cords at doors,
plugs, receptacles, and the point where they exit from the
product.
– Foradded protection of this product duringalightningstorm,
or when it is left unattended and unused for long periods of
time, unplug it from the wall outlet and disconnect the cable
system.This will preventdamagetotheproductdue to light-
ning and power line surges.
– Donotoverloadwall outlets,extensioncords,orconvenience
receptacles on other equipment as this can result in a risk
of fire or electric shock.
– Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or
short out parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
– Do not attempt to service this product yourself as opening
or removing covers may expose you to dangerous voltages
andotherhazards.Referallserviceto qualified service per-
sonnel.
– Unplug this product from the wall outlet and refer service to
qualified service personnel under the following conditions:
a) When the power supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen on the
product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the
operatinginstructions.Adjustonlythose controls that are
covered by the Operation Manual, as an improper ad-
justment of controls may result in damage and will often
require extensive work by a qualified technician to re-
store the product to normal operation.
e) Iftheproducthas been dropped or damaged in any way.
f) When the product exhibits a distinct change in perfor-
mance - this indicates a need for service.
– When replacement parts are required, be sure the service
technician has used replacement parts specified by the
manufacturer or with same characteristics as the original
part. Unauthorized substitutions may result in fire, electric
shock, or other hazards.
– Upon completion of any service or repairs to this product,
ask the service technician to perform safety checks to de-
termine that the product is in proper operating condition.
–Theproductshouldbeplacedmorethanonefootawayfrom
heat sources such as radiators, heat registers, stoves, and
other products (including amplifiers) that produce heat.
–When connecting other products such as VCR’s, and per-
sonal computers, you should turn off the power of this prod-
uct for protection against electric shock.
–Do not place combustibles behind the cooling fan. For ex-
ample, cloth, paper, matches, aerosol cans or gas lighters
that present special hazards when over heated.
– Do not look into the projection lens while the illumination
lamp is turned on. Exposure of your eyes to the strong light
can result in impaired eyesight.
–Do not look into the inside of this unit through vents (ventila-
tion holes), etc. Do not look at the illumination lamp directly
by opening the cabinet while the illumination lamp is turned
on. The illumination lamp also contains ultraviolet rays and
the light is so powerful that your eyesight can be impaired.
–Donotdrop,hit,ordamagethelight-source lamp (lamp unit)
in any way. It may cause the light-source lamp to break and
lead to injuries. Do not use a damaged light source lamp. If
the light-source lamp is broken, ask your dealer to repair it.
Fragmentsfroma broken light-source lamp may cause inju-
ries.
– The light-source lamp used in this projector is a high pres-
sure mercury lamp. Be careful when disposing of the light-
source lamp. If anything is unclear, please consult your
dealer.
– Do not ceiling-mount the projector to a place which tends to
vibrate;otherwise,the attaching fixture of the projector could
bebroken by the vibration, possiblycausing it to fall orover-
turn, which could lead to personal injury.
– Use only the accessory cord designed for this product to
preventshock.
The power supply voltage rating of this product isAC 120 V,
AC 100 V–AC 240 V, the power cord attached conforms to
thefollowingpowersupplyvoltage.Useonly the power cord
designated by our dealer to ensure Safety and EMC.
When it is used by other power supply voltage, power cable
must be changed.
Ensure that the power cable used for the projector is the
correct type for the AC outlet in your country.
Consult your product dealer.
*DO NOT allow any unqualified person to install the unit.
Be sure to ask your dealer to install the unit (e.g. attaching
itto the ceiling)sincespecial technical knowledge andskills
are required for installation.
Ifinstallation is performed by an unqualified person, itmay
cause personal injury or electrical shock.
Power cord
For United
Kingdom For European
continent countries
Power supply voltage: AC 120 V
Power cord
