Metalux VT3 User manual

IMPORTANT - PLEASE READ
To Mount the Unit:
Step 1. Locate the studs in the back of the housing and using the brackets and hardware provided, secure them in place.
Proceed to mount the unit (hardware by other depending on the application). - Figure 1
Step 2. Disengage the latches and remove the lens. - Figure 2
Step 3. Compress gear tray latches in order to release the gear tray from the housing. The lanyards installed will hold it during
the installation. - Figures 3 & 4
VT3 Installation Instructions
1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 ADF071638 0590-VT3
Figure 1 Figure 2
B
Figure 3 Figure 4
Risk of Fire/Electric Shock
If not Qualified, Consult an
Electrician
WARNING
Risk Electric Shock.
Disconnect power at fuse
or circuit breaker before
installing or servicing.
WARNING
Edges May Cut.
Handle with care.
WARNING

1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 ADF071638 0590-VT3
Figure 5
Step 4. Locate the conduit hubs included in the parts bag and install them on each end of the unit. Perform the electrical
installation according to code. Make provisions for the power supply to have additional 12” of wire to ease
maintenance. - Figure 5
Step 5. Insert gear tray into the housing until it engages the clips and secures in place. - Figure 6
Step 6. Install the Lamps, center the Lens in the unit and close all the latches. - Figure 7
VT3 Installation Instructions
Figure 6 Figure 7