METHVEN Futura 02-4308 User manual

Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
www.methven.com
SEPT 2009 MA43081
Futura Sink Mixer
02-4308
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
Illustration may not reflect actual product shape.
Illustration may not reflect actual product shape.
Hot
Max 40mm
Cold
35mm
dia.
Spec 001
LN:WMK 21726

We recommend that this product is installed by a licensed plumber.
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
Technical Specifications Installation
Refer to diagram at right and back.
Hose Requirements for mixers
The maximum working pressure of the ceramic cartridge is 1000kPa.
Do not hydrostatic test the installation with this mixer installed. Damage to
the ceramic cartridge may occur.
Inlet Connections: All 1/2’ BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.
“In situ” testing
Ceramic Cartridge Adjustment
Do not remove the ceramic cartridge from the body assembly while carrying
out the following adjustments. Note, the cartridge is factory set for maximum
temperature
Flow control grub
screw access hole
Raised portion of ring
to the front of the faucet
Temperature limiting ring
Maximum hot supply (as fitted in faucet) Maximum limitation of hot supply
1. A single 35mm diameter hole is required in the
mounting surface. The mounting surface can be a
maximum of 40mm thick.
2. Screw the threaded studs into the base of the mixer.
Insert the O ring into the groove in the bottom of the
base ring and fit the base ring to the bottom of the
mixer.
3. Insert the flexible hoses through the hole in the
mounting surface (from the underside) and screw
them into the base of the mixer.
4. Feed the threaded studs through the hole in the mounting surface. Fit the mounting
gasket and mounting plate onto the threaded rods.
5. Tighten the mounting nuts to secure the mixer in place.
6. Connect the flexible hoses to the hot and cold supplies (hot on the left,
cold on the right).