METHVEN Deva IND104 User manual

Indi Sink Mixer
IND104
Installation Guide
Technical Specification
Working Pressure:
Min:
Max:
Operating Temperature:
Hot:
Cold:
0.3 Bar
5.0 Bar
65⁰C
5⁰C
METHVEN UK LIMITED
METHVEN EXPERIENCE CENTRE
3/3A STONE CROSS COURT
YEW TREE WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
INST-IND104
02.03.2020
TEL: [phone]
FAX: [phone]
EMAIL: [email protected]
www.deva-uk.com
www.methven.com
Warranty Information
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by incorrect
installation and/or maintenance, ordinary wear and tear, water
composition, etc.
*Please see www.deva-uk for full terms and conditions of warranty
Cleaning
Your product has a high-quality finish and should be treated with care
to preserve the visible surfaces. Never use abrasives or abrasive
cleaning agents to clean this product clean regularly with
contamination free warm water and a damp soft cloth. Do not use
products containing chlorine bleach or hydrochloric acid as these can
damage the product.
We have a policy of continuous improvement and reserve the right to
change specifications without notice.
Inlet Connections:
½" BSP
Features:
•Swivel spout
•Ceramic Cartridge
•Tilt and Turn Temperature and Flow
Control

7
2
Contents
Congratulations on your purchase of your new Deva by Methven Sink Mixer.
Our fitting instructions have been created with you in mind to provide you
with all the information you require and, if you need any further help, please
don't hesitate to contact our customer care team on 0800 195 1602.
General Safety Information
Line Drawing
Product Breakdown
Product Breakdown
Installation Requirements
Installation
Troubleshooting
Warranty Information
Cleaning
3
3
Troubleshooting
4
6
4
6
7
8
8

63
Please keep these instructions for future reference and request of replacement
parts
General Safety Information
Please read all of the instructions before installation.
Methven recommends this product is installed by a competent person in
compliance with all relevant regional regulations.
Remove all packaging and check the components for damage before starting
installation.
This product must not be modified in any way as this will invalidate the guarantee.
It is the responsibility of the installer to ensure a waterproof seal is achieved, after
installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe
temperature as per regional regulations.
Line Drawing
Installation Requirements
Before commencing installation of the new product, ensure that the system has
been flushed to remove any debris, which could cause damage to the valves and
invalidate the warranty.
Installation
1, Screw the threaded fixing bolt into the bottom of the mixer body
2, Screw both Flexi Tails into the tap body, ensuring that the O-Ring on the
tail is positioned inside the tap body. Hand tighten, do not use PTFE tape or
similar to create the seal.
3, Offer the tap up to the hole in the sink
4, On the underside of the sink fit the
rubber and metal horseshoe shaped
washers onto the threaded fixing bolt and
using the nut provided tighten until the
tap is secure in the mounting hole.
Note: Plastic Triangle - If required a under
sink mounting triangle can be purchased,
this should be used on thin work surfaces
to help distribute the weight of the tap
and provide a thicker mounting surface
for the fixing kit to clamp to.
5, Connect the male end of the tail to the
corresponding hot and cold inlets.
6, Reinstate water supply and test for
leaks.

Product Breakdown
Check All components are present prior to starting installation.