METHVEN ROUND RAIL User manual

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
www.methven.com
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the filter washer should be removed from the end of the shower hose and cleaned.
Care and Cleaning:
 ISSUE B
Technical Specifications:
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
ROUND RAIL
Installation Guide
•
Step 1
Wall lining hole should be cut or finished as per
the dimension shown in the diagram on the right.
Cut off the threaded nipple 13±2mm from the wall
lining and apply thread seal tape to ensure a
good seal.
•
Step 2
Screw the elbow onto the nipple ensuring
that the o-ring is sufficiently compressed to
create a watertight seal.
Ensure that the elbow is oriented vertically
with the outlet oriented downwards.
•
•
Elbow Installation (if supplied):
13±2mm
26mm max

Step 2
Rail can be orientated so that handset sits on
opposite side of the rail.
Slide soap dish onto the rail (if supplied).
Slide hose retainer onto the rail (if supplied).
Step 3
Fit the internal mounting
brackets by locating in slot
and rotating 90°.
Step 4
Tighten the tensioning screws lightly with the hex key provided.
Step 5
Match the mounting brackets to wall bosses and push
into place.
Slide the rail up or down to centralise the brackets.
Remove the rail and tighten the tensioning screws firmly.
Relocate the rail onto wall bosses and tighten grub
screws top and bottom.
•
•
•
•
•
•
•
•
Step 1
Mount the wall boss housings in
desired position with the screws. Check
the mounts are vertically aligned.
Ensure the grub screws are located on
the correct sides as shown.
Ensure protection pads are used
between wall bosses and tiles.
•
Step 6
To adjust slider position, rotate the slider
handle to unlock and lock the slider as shown.
IF HANDSET, HOSE OR WATER OUTLET ARE
SUPPLIED: Connect hose to water outlet and
Methven handset. Ensure swivelling cone is
connected to the handset.
•
•
Unlock
Lock
grub screw
topside
grub screw
underside
FLOOR
800mm RAIL 595 - 730mm
1850mm (recommended)
VERTICAL
Wall Boss Housing
Grub Srew
Rail
Slider
Internal Mounting
Bracket and Screw
Wall Boss Screws
Water Outlet
(If supplied)
Soap Dish
(If supplied)
This product must be installed in
compliance with all relevant regional
regulations.
It is the responsibility of the installer to
ensure a waterproof seal is achieved
between the product and mounting
surface. If in doubt about the quality of
the seal, remove the product and
reinstall using silicone to ensure a seal is
achieved.
All pipe work must be thoroughly flushed
prior to the installation of the hose.
After installation all connections must be
checked for leaks.
All outlets used primarily for personal
hygiene shall deliver water at a safe
temperature as per regional regulations.
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
•