MEXDA WS-1103 User manual

MODEL:WS-1103
MICA HEATING BOARD SAUNA ROOM
INSTRUCTION MANUAL
SAUNA ROOM
No advanced advice will be submit before we change our design and size.
The pictures may be a little different from the real products.
Our company keep the final explanation right.

1
1. Users should read through this manual before assembly and
use.
2. The product must install a reliable earth line and electricity
leak protection.
3. Users should install power supply according to actual
condition.
4. Patients with hypertension or drunk are not permitted to use
this products.
5. Adult guidance is necessary for children or under age to use
sauna.
6. Corrosive liquid are not allowed to bring into the room.
7. Sauna room must not over working for long time. The heat pipe
may damage of long time heating.
8. Our company would not take responsibility if the product is
damaged but caused by violating the normal operating
procedures.
9. When the product is discarded, please deal with it according to
local law.
ATTENTION
TECHNICAL PARAMETERS
1. rated voltage: AC220V±10％ 50Hz/60Hz
2.Power of Sauna heater: 3000w
3. Size:1800X1050X1900m m
1500X1050X1900mm
1200X1050X1900
M ni
CD/ FM mod e dis pla y
Tim e dis pla y
lef t
up
CD/ FM
Co nf ir m ke y
Vol ume mod e dis pla y
Celsius temperature/
temperat u r e m ode display
Fahrenhe i t
rig ht
Lig ht
ON/ OFF
Control Panel Description
Sau na
dow n

二、Fun c tion D e scri p tion
一、Fun c tion I n trod u ctio n
1 . ；sauna heater 2 . Light Output 3、C D
1、On/Off
In the state of power，pr ess the key to start up，
showed the en viron mental temperatu re and wo rking time
press the key a gain th en closs the system。
2、CD
4、Sauna
In the state of power on，press the key on the panel，move the cursor on the Light
press the key on the panel open the light；Press the key again,the light then close.
3、Light
In the state of power on，press the key on the panel，move the
cursor on the music.press the key open the CD ,Press the key the second
time FM the third time then close.
5、Tempera ture
In t he st ate o f powe r on, press the key on the panel，move
the cursor on the the system into heating temperature setting
mode，then press the one the panel can increase or decrease
the temperature（The lowest setting temperature is 15 , the maximum
setting temperature is 90 , the system moidentify temperature is
32 ）Press the key again,the system automatically switches
to the Fahrenheit temperature patterns show the current
ambient temperature
In the state of power on，press the key on the panel，move the
cursor on the Steam press the key on the panel open the sauna
stove；Press the key again,the sauna stove then close
When the s ystem is in standby mode,
the s yste m automatically locks keys.
Pres s the a few seconds,
the s yste m unlock key.
5. .:Fahrenheit / Cels ius te mper ature function
5、Tempera ture

3
SPARE PART
1
2
3
4
5
2
SKETCH
1.body
3.top
2.sauna heater
4.Glass
5.Hinge

1.Base f ram e and
side p lat e lin k
4.install the seat
to the room
INSTALLATION DIAGRAM
SPARE PART
instal Ф6×80MM Screw

5.installation completed
3.
wall on Side
install front
4.install the top.
instal Ф6×80MM Screw