MicrohDJ MINI-VIRUS User manual

www.microhdj.com
Model: MINI-VIRUS
User Manual

Thanks for your purchasing, please read this manual carefully before operating the system. It
gives you general information for your safety and better operation.
Inspection
Check for the contents in the package refers to the following list:
1. Laser light: 1
2. Remote controller: 1
3. Power cable: 1
3. User manual: 1
Installation
1. Firstly, be sure that the using voltage is match with the voltage
marked on the base of the laser lighting ;
2. Installation should be made by professional technician. Fix the
laser and adjust the angle of the laser lighting to your need;
3. Be sure that there is no flammable or explosive subject nearby.
The least distance is 0.5 meters.At the same time, keep more
than 15cm between the wall and laser lighting;
4. Please check whether the fan and the exhaust are blocked;
5. There is a hole for connection. When hang the laser lighting, be
sure the cable can undertake 10 times of the lighting weight;
6. The laser lighting should be fixed;
7. It is essential to be earthed well for the sake of safety.
Technical parameters
1. Laser diode: DPSS, Red 650nm, Green 532nm
2. Power supply：DC12V. Adaptor: AC110V--240V, 50/60Hz
3. Laser power：Green 30mW
4. Motor: N1.8 high precision step motor
5. Control mode：Sound control/AUTO, Remote Control
6. Dimensions：27 ×19 ×13cm
7. Net weight：0. 7KG
8 .Gross weight：0.85KG
----------------- 1 -------------------

Remote Control Setting
When using the remote controller, take the plastic card out of it.
: Laser ON/OFF
AUTO: Set in Auto Mode
MIC: Set in Sound Mode
When you lose the remote controller, you can press the button of MODE in the rear
panel to choose the working mode. Or you can contact your supplier to get a new
remote controller.
Warning
•Power off before installation or maintenance;
•The danger class of this laser lighting is CLASS III B. It’s dangerous for
observing laser.
•Keep at least 0.5 meters distance between the lighting and flammable
material;
---------------- 2 -------------------

Notices
•Non-professional do not dismantle or repair the laser lighting.
•When there is a problem, please inquire with the professional
or contact with the local dealer;
•Do not exposure in the wet or dirty condition;
•Prevent the laser lighting from strong vibration or punch;
•Prevent other subject enter into the lighting;
•Ensure the fan is not blocked;
•Before power on, be sure electric outlet is connected well with
the socket;
•Do not turn on and turn off frequently, avoid to turn on the
power for a long time;
•Please power off the lighting for 15 minutes after running two
hours, ensure that the laser system is in well cooling state;
•Please clean the lighting surface and lens regularly. It is recommended that
should be cleaned every 30 days;
•Do not do it using the wet cloth or other chemical.
•Do not looking at the laser source using telescope
•Do not touch the laser lighting by wet hand and forcefully pull
the power line;
•The distance between lighting and casting medium should be
more than 1 meters;
•When to be transported, use the original package.
-----------------3 -------------------