2
SP922 series is an outdoor solution 500mW/1W bi-directional
booster designed for 2.4 GHz wireless LAN. This unit comes
with an easy plug-and-play installation, which works together
with an indoor Wireless Access point to improve its operation
rage and performance. The unit is ideal for use with 2.4Ghz
Frequency Hopping or Direct Sequence Spread Spectrum radio
modems and 11 Mbit/sec IEEE 802.11b devices.
Introduction
Package contents for SP922-500 / SP922-1000
• Micronet
•
•
•
•
•
•
SP922 WLAN Auto Gain Booster
DC Injector
Quick Installation Manual
DC Adapter 6V 2A
Rot mount unit
N-type male to N-type male cable
N-type male to SMA female cable
1
3 4
Installation
Model SP922-500
Operation Range 2400~2500MHz
Transmit Gain 27dB
Frequency Response +
-
1dB over operating range
Output Power 500mW
Receiver Gain
Noise Figure
Lightning Protection Direct DC ground at antenna connector
DC Surge Protection at 5V DC input form transmission cable
Operating Temperature -20 to 70 C
Operating Humidity
Power Supply AC 100-250V, DC 6V, 2A
Booster Dimension 11.5cm x 6.5cm x 4.5cm
11.5cm x 6.5cm x 4.5cm
(LxWxH)
DC Injector Dimension (LxWxH)
up to 100% relative humidity
Specification
SP922-1000
30dB
1W
Impedance
15 dB typical
3.5 dB typical
50 ohm
Step 5.
Adjust antenna director
for optimum signal
Step 3.
Connect to
outdoor
antenna
Step 2.
Connect DC injector and
Auto Gain Booster with
C920F-1 Cable
Step 4.
Plug in the Power adapter
to the Amplifier DC injector
Step 1.
Connect ro WLAN Access Point
less than 50cm
To Radio
INDOOR
DC Injector
Item Connector on DC Injector
1 N-Type(Female)
2 N-Type(Female)
3 N-Type(Female)
4 N-Type(Female)
OUTDOOR
For best performance, please always keep cable distance
from booster to antenna less than 50cm.
TO Amplifier TO Radio
