MIGEL GRV 21 User manual
GRV 21
–
–
–
–
–
GRV 21
–
–
–
–
–
–
–
–
–
–
–
3
4
–
–
–
–
–
–
–
–
5
–
–
–
-9
ىژرﺎﺷ ورﺎﺟ
-9
Note
Note
Note
9. Scrape along the locating slot of rolling brush with blade (see Fig.19) to
cut the hair and clean, then install the Floor brush well in position, after it,
fasten the Release button of rolling brush.
10. It is suggested that the Dust cup shall be cleaned in time after working
each time. The HEPA lter shall be cleaned or replaced when it is blocked
by too much dust.For ensuring the eciency of Vacuum Cleaner, the
rolling brush shall be cleaned after being used for a long time as it will be
wound by hair etc.
You can help protect the environment!
Please remember to respect the local regulations: Hand in the
non-working electrical equipments to an appropriate waste
disposal centre.
CHARGING OPERATION
8
Fig 18
Fig 19
5. Grasp the Filter handle (3) and rotate it anticlockwise to remove the
HEPA lter (6), then empty the rubbish in the Filter cover (5) and rinse it
with water. Wipe the residual water left on the Filter cover (see Fig.16).
6. Clean the HEPA lter (6) with water when the sucking performance
degrades, but it must be dried completely after being cleaned.
Note: HEPA lter and other spare parts can be purchased from the seller.
7. After nish cleaning, rstly install the HEPA lter into the Filter cover,
then install them into the Dust cup, after it, install the Dust cup into the
Sub unit (see Fig.17).
8. When there is hair wound in the oor brush, rstly reverse the oor
brush and then unlock the Release button of rolling brush (7) to remove
the Rolling brush (8) (see Fig.18).
left on the Dust cup (see Fig.15).
7
5
Fig 16
Fig 15
Fig 17
CHARGING OPERATION
1. Insert the smaller end of Power adapter (8) into the charging hole of Sub
unit by following the direction shown in Fig.12.
2. Insert the larger end of Power adapter into socket (see Fig.13), the
Battery indicators light up successively and the appliance enters into
charging condition.The charging is nished when all the Battery indicators
illuminate. The appliance can not be activated during charging.
3. Detach the accessory from the Sub unit, then press down the Dust cup
release button (1) to remove the Dust cup (2) from the Sub uni (see Fig.14).
4. Grasp the Filter handle (3) to move the Filter assembly (4) out of the Dust
cup, then empty the Dust cup and rinse it with water. Wipe the residual
water
6
Fig 14
Table of contents
Languages:
Other MIGEL Vacuum Cleaner manuals
