Milesight LoRaWAN EM320-TH User manual

EM320-TH
Quick Start Guide Cloud App
www.milesight-iot.comMilesight IoT Co., Ltd.
All software & files can be downloaded from
https://www.milesight-iot.com/documents-download/
1. Packing List
SMART IoT SENSOR
FEATURING LǝRaWAN®
2. Hardware Introduction
3. Power Button
EM320-TH equips with power button and indicator inside to switch
on/off the device for emergency use. Usually users can use NFC to
complete all steps.
OR
WAN
®
1 × EM320-TH Sensor
Standard Version Only
1 × Quick Start Guide
2 × Wall Mounting Kits
1 × Warranty Card
SeriesQuick Guide
1 × Fixing Screw
Function
Turn On Press and hold the button for more
than 3 seconds.
Press and hold the button for more
than 3 seconds.
Press and hold the button for more
than 10 seconds.
Quickly press the power button.
Light Off: Device is off.
Off→On
On→Off
Blinks quickly
Light On: Device is on.
Turn Off
Reset
Check On/
Off Status
Action LED
Vent
NFC Area
Building C09, Software Park Phase III, Xiamen 361024, Fujian, China

4. Configuration Guide
1. Download “Milesight ToolBox” App on an NFC-supported smartphone.
2. Open “Milesight ToolBox” App and attach the smartphone with NFC
area to read/write the device until App shows a successful prompt. It’s
suggested to configure a device password for security.
(Default password: 123456)
iOS
Android
5. Installation
6. Installation
Besides, it can be configured by dedicated NFC reader provided by
Milesight IoT.
1. Remove the backplate on the back of the device, screw the wall plugs
into the wall and fix the backplate with screws on it, then install back the
device. Note that the vent of device should not face upwards when installing.
Attach the device to a magnetic surface such as the metal surface of
the refrigerator, freezer, freight container, etc. The back of the device
is equipped with anti-slip pad to secure firm and sturdy installation.
Note that the vent should not face upwards.
2. Fix the bottom of the device to the cover with a fixing screw.
Standard Version:
Magnetic Version:
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator& your body. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.