In order to get best transmission, ensure the device is within the
signal range of the LoRaWAN gateway and avoid the obstacles.
Do not overload the maximum capacity in order to avoid the damage
of the device. The max load capacity may vary by models and you
can scan the QR code of Quick Start Guide for more information.
The device is intended only for indoor use. Do not place device
outdoors where the temperature is below/above operating
temperature; do not place the device close to objects with naked
flames, heat source (oven or sunlight), cold source, liquid and extreme
temperature changes.
Keep the device away from water to prevent electric shock.
Use the device only in clean environments. Dusty or dirty environments
may prevent the proper operation of this device.
Do not drop the device or subject it to physical shocks and strong
vibration.
Use a dry, clean cloth to clean the device. Do not use strong
chemicals or detergents which may damage the device.
All Software & files can be downloaded from
https://www.milesight-iot.com/documents-download/
Cloud App Quick Start Guide
Milesight IoT Co., Ltd. www.milesight-iot.com
®
NFC
Press the power button, then the socket can supply the power
to appliances.
Step 3:
6. Safety Precautions
Milesight IoT Display is in conformity with the essential requirements and other
relevant provisions of the CE and FCC.
5. Declaration of Conformity
6. FCC Statement
FCC Radiation Exposure Statement:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator& your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4.Consult the dealer or an experienced radio/TV technician for help.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
Add:Building C09,Software Park Phase？III,Xiamen 361024,Fujian,China
